Targus MIRALOGIC Quick Start Manual

MIRALOGIC SMART POWER STRIP
Introduction
Congratulations on your purchase of the Targus Miralogic Smart Power Strip.
Contents
(A) Miralogic Smart Power Strip
(B) User Guide
Features
• Stylish design for enterprise and office use.
• Capture power consumption data on each individual device plugged into the outlets.
• Deliver power consumpton analytics to the Miralogic Software Platform via the
Universal Smart Dock.
• Each outlet can be remotely managed (e.g. turned on / off) via the Miralogic
Software Platform.
Technical Specification
Number of AC outlets: 4
Maximum Current or Power: 120V, 8A or 960 watts
Input: 120VAC 60Hz 8A Max
Output: 120VAC 60Hz 8A Total (5A max per outlet)
Intended Use
This product is intended for enterprise use only. It is not intended for household use.
This product is intended to be used in dry indoor area only.
No liability will be accepted for damaged resulting from improper use or non-
compliance with these instructions.
Before First Use
Check for any transport damages.
Before connecting the product to the power source, check that the power supply
voltage corresponds with the input line voltage details shown on the rating label.
Using the Product
Connecting to a power source
Place the product nearby the power source and connect the power plug.
Power switch indicator (Red): The product is powered on.
Not Grounded (Red): The power is not grounded.
Power indicator (Green): The product is powered on.
Connected indicator (Blue): The product is successfully connected to the Miralogic
Software Platform via the Universal Smart Dock.
(A)
Circuit breaker
DO NOT OVERLOAD the product's outlets. The product can accommodate a total AC
loading up to 8A (960W) (spread out over multiple outlets but single outlet can only
withstand a maximum of 5A). If the AC loading exceeds 960W, the built-in circuit
breaker (inside the power rocker switch) will trip and the outlets will stop providing
power immediately (red indicator goes off).
In case the circuit breaker trips, proceed as below:
1. Unplug all the connected equipment.
2. Press the power rocker switch and make sure the red indicator is on.
3. Connect all the equipment one by one. While doing so, do not exceed a total AC
loading of 960W.
Cleaning and Maintenance
To prevent electric shock, unplug before cleaning
During cleaning, the electrical parts of the product shall not be immersed into water
or other liquids. Never hold it under running water.
Cleaning
• Unplug the product from the wall AC outlet, wipe with a soft, slightly moist cloth.
• Dry the product after cleaning.
• Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp
utensils to clean the product.
Maintenance
• Store in a cool and dry place away from children and pets.
• Avoid any vibrations and mechanical shocks.
(B)
User Guide
APS811 / 410-3882-001B