Regin IR24-P Instructions Manual

INSTRUCTION
EN
IR24-P
i
Read this instruction before installation
and wiring of the product
Motion detector
IR24-P is a passive infrared motion detector suitable for use in "on
demand" control of ventilation systems or in intrusion alarm circuits.
Technical data
Infrared sensor Dual element
Supply voltage 24 ± 2 V AC/DC
Detection range 15 x 15 m, 110° angle
Power consumption 5 mA at 24 V AC
Output 200 mA, 24 V AC/DC, potential-free
change-over relay
Ambient humidity Max. 95% RH
Temperature range -20...+50°C
Protection class IP20
Mounting bracket MB-100
Mounting height 1.8...3.6 m
Detectable speed 0.1...3.0 m/s
ON-delay 0, 10, 30, 60, 300 or 600 s (selectable)
OFF-delay 10, 60, 300, 600, 1200 or 1800 s
(selectable)
Dimensions (HxWxD) 112 x 66 x 45
Cable hole
Corner mount
Jumpers
Fig. 1 IR24-P
Detection pattern
110°, 15 x 15 m, 110° Plan view
2,4m
Side view
2,5m 10m 15m
IR24-P
Mounting
For best coverage, IR24-P should be placed 6...8 ft above floor level
Terminal
in a location with an unhindered view of the area to be monitored.
Avoid exposure to direct sunlight or other powerful heat sources.
For corner mounting the two corner mounting holes in the casing
may be used. For other wall mounting or for ceiling mounting use
the supplied mounting bracket. Fasten the bracket according to the
appropriate figure. Fasten the unit to the bracket and lead the cable
LEDs
through the access tube in the bracket and through the cable hole in
the housing.
Align the unit and lock in position by tightening the locking screw on
Sensor
the bracket. Replace the front cover.
NB: Don't touch!
Ceiling mounting
22mm
Cover screw
1
Locking screw
Fig. 2 Installation of the mounting bracket
1
Fig. 3 Mounting the unit on the bracket
Wall mounting
2
1
8mm
3
2
End-cap*
End-cap*
* The end-cap can be used to
cover the back of the bracket
2
3
3
5
4
6
1