Subscribe to Our Youtube Channel
Summary of Contents for Autopilot APCG4LP
-
Page 1: Table Of Contents
Autopilot 4 Burner CO Generator (LP or NG) Specs Natural gas or Propane Installation Start Up Procedure High Altitude units Electronic Ignition Module LED Indicators Q & A 9-10 Warnings... -
Page 2: Specs
Page 1 APCG4 Specs Power Requirements 400 ma @ 24VDC # of Burners / material 4 precision brass BTU Rating LP 9,052 NG 11,068 Cubic Ft CO2 per hour 11 SCFH Natural Gas (NG) Pressure 4.5” WC / 1.15 kpa Propane Gas (LP) Pressure 11”... -
Page 3: Natural Gas Or Propane
Page 2 APCG4 Natural gas or Propane There are 2 types of generators available, Natural Gas (NG) or Liquid Propane (LP). Both units come with the correct regulator and hose, along with pre-installed, clean-burning brass burners. Both units are equipped with features like a safety tip-over switch, to automatically turn off the unit completely should it tip over or fall and an electronic ignition, which eliminates the open pilot flame. -
Page 4: Installation
Page 3 APCG4 Installation Determine the best location for the generator. It must be hung level in an area that is adequately ventilated. !!Warning!! In closed spaces without adequate ventilation, CO2 levels can accumulate and become toxic (CO2 levels above 5000 PPM are toxic) Plants benefit from levels up to 1500PPM. - Page 5 Page 4 APCG4 Pressurize the gas line after connections are verified. Use soapy water and a spray bottle to check for leaks by spraying it onto the gas connection (fittings) and watch for bubbles. If bubbles appear re-secure connection and repeat process. Using the included power supply, connect the unit to a controller or timer that will determine the amount of time and how frequent the generator will operate.
-
Page 6: Start Up Procedure
Page 5 APCG4 Start Up Procedure After completing the installation, follow this start up procedure. Verify the power switch is off and the unit is not plugged in. Verify there are no foreign objects or loose packing materials on the inside of the unit. Make sure nothing appears damaged or out of place. - Page 7 Page 6 APCG4 Start Up Procedure (cont) The unit should fire before 5 attempts however, after 5 unsuccessful attempts, the module will lock itself out and the LED light next to “Lock Out (error)” will be illuminated. Turn off the unit and wait 5 minutes to allow the gas to dissipate. Retry to start the generator.
-
Page 8: High Altitude Units
Page 7 APCG4 High Altitude units The standard brass burners have been designed to operate correctly at an altitude between sea level and 4500 Ft of elevation. If you are at an altitude higher than 4500 feet, do not use the standard unit if yellow flames are visible. HA (High Altitude) burners are available by contacting the factory. -
Page 9: Electronic Ignition Module
Page 8 APCG4 Electronic Ignition Control Module , the For safer operation APCG4 has an Electronic Ignition Control Module that eliminates the “open” pilot flame. The module creates a spark that lights the burner(s), providing consistent and controlled starts. The dual redundant solenoid valves are controlled by the ignition controller. -
Page 10: Q & A
Page 9 APCG4 Q & A Should there be a gas smell in the area? NO. Turn off the gas supply immediately, Do not turn on any electrical devices. Ventilate the area by opening vents, doors, or windows. Leave the area until the gas smell is no longer present. Once ventilated and the gas smell is gone, determine where the leak is by using soapy water. - Page 11 Page 10 APCG4 Q & A The grow area is getting too humid or hot? Remove the left burner and replace with the supplied pipe plug. This will reduce heat and humidity. Should the APCG4 be buzzing and / or sparking? Yes, when the unit is firing you will hear “sparking”...
-
Page 12: Warnings
Page 11 APCG4 If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. * Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. - Page 13 Page 12 APCG4 IMPORTANT MESSAGE Read and understand this instruction manual BEFORE attempting to operate this product. Failure to do so could result in personal injury and / or property damage. Made in China...
Need help?
Do you have a question about the APCG4LP and is the answer not in the manual?
Questions and answers