Table of Contents
Advertisement
Using Microsoft
HyperTerminal
Computer Interfaces 4-24
Menu preferences are not normally retained after the power is
removed from the instrument. To make (a) menu preference(s)
permanent, make the desired change(s) to settings first and
then proceed to the section Storing the Menu Preferences to
make the changes permanent. Following this procedure will
put the settings into non-volatile memory and allow them to
be restored during instrument power-up.
One of the easiest ways to manually control the 1257 through the
RS-232 interface is to use HyperTerminal. HyperTerminal is a
terminal emulation program that is included with Windows 95 and
98.
Before using HyperTerminal, or any other terminal emulation
program, set up the 1257 RS-232 parameters as follows (refer to
the above sections for details about accessing these settings via
the front-panel controls):
Baud rate:
Data Bits:
Parity:
Stop Bits:
Flow Control:
EOL Mode:
To run HyperTerminal, click on Start, click on Run, then type:
hypertrm
(use the exact spelling above). Then press Enter.
The HyperTerminal program then starts, and displays the
Connection Description dialog box as shown in Figure 4-5.
NOTE:
9600
8
None
1
Disabled
CR/LF
EADS North America Defense
Test and Services, Inc. © 2001
1257 User Manual
Advertisement
Table of Contents
