Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for AQUAPHOR CRYSTAL EKO-80-2
- Page 1 DRINKING WATER FOUNTAIN CRYSTAL MODEL EKO-80-2 CRYSTAL MODEL H-80-2 USER MANUAL...
-
Page 2: Technical Parameters
INTRODUCTION The Aquaphor drinking water fountain (further referred to as the water fountain), is manufactured by AQUABOSS Ltd. (Russia, Saint Petersburg) for AQUAPHOR Ltd (Russia, Saint Petersburg). The water fountain provides access to pure and fresh water. It can be utilized in various... - Page 3 (15, 16, 17). The cabinet is equipped with a valve to protect against flooding, and an electronic Aquaphor cartridge wear counter. The water flowing in from the water mains is filtered, and then, on pressing a button, is available to the user in the spout (5) .
-
Page 4: Installation Diagram
INSTALLATION DIAGRAM WATER FOUNTAIN INSTALLATION AND CONNECTIONS Please note: Before installing the water fountain, you need to measure the pressure in the water supply system. If the pressure exceeds 6.3 atmospheres, an additional pressure regulator should be installed. (not included in the unit). Choosing a suitable location to install the water fountain The water fountain should be placed on an even, horizontal surface. - Page 5 Position the dispenser in such a way that it is protected from direct sunlight. Make sure there are no heating devices around. The distance between the water fountain and any household appliance should not be less than 20 cm. The water fountain must be protected against freezing.
- Page 6 10 cm. Preparation of the AQUAPHOR electronic cartridge wear meter for use (13) (Fig. 4) The electronic cartridge wear counter allows you to control the wear of cartridges in the water fountain and prompts timely replacement.
- Page 7 FOLLOWING THE WATER FOUNTAIN INSTALLATION AND CONNECTION In the case of the Crystal EKО-80-2 water fountain: - open the cold water supply, check the tightness of the device; - open the clean water tap (5); - using the water connection (2) (set the handle to the "open tap" position), adjust the water flow in accordance with the recommended filtration rate of the device;...
- Page 8 THE WATER FOUNTAIN OPERATION Filter cartridges replacement: The replaceable filter cartridges originally installed in the dispenser are right for the model. It is recommended to replace the filter cartridges in a timely manner. REMEMBER that a dispenser with used cartridges is unusable. 1 - push 1 - insert 2 - turn...
- Page 9 The inlet/outlet is marked with an arrow on the plastic part of the valve screen (It is important that the valve handle is in a horizontal position). AQUAPHOR cartridge wear electronic counter The timer turns on automatically when water starts flowing through it and turns off 10 seconds after the water stops flowing.
- Page 10 Signals The end of filter service life signal When 30 litres or 7 days of filter service life is left, A SINGLE beep will sound, and the display will flash the values to indicate the need to replace the filter cartridge soon. The sound signal will stop when the meter is turned on using the "SET"...
-
Page 11: Manufacturer's Warranty
It is perfect for quenching thirst after a class or at work. The AQUAPHOR water pre-filter (at the water connection to the building) helps the filter to operate more efficiently, especially if the water contains large amounts of undissolved... -
Page 12: Troubleshooting
TROUBLESHOOTING Cause Remedy 1. The ball valve is closed 1. Open the water connection. (water connection)? 2. Bent hoses? 2. Straighten the hoses. 3. Has the shut-off valve cut 3. Replace the shut-off valve. No water off the water supply? 4.
Need help?
Do you have a question about the CRYSTAL EKO-80-2 and is the answer not in the manual?
Questions and answers