Optec QuickSync FT20 Installation Manual

FocusLynx FT QuickSync Installation
Step-by-Step Instructions for Installing the QuickSync FT Motor
Assembly to your FeatherTouch Focuser.
The QuickSync motor assembly fits directly in place of the coarse and fine focus knobs on the right side
of the FeatherTouch manual
focusers. The gold knob on the
QuickSync will attach to the smaller
diameter shaft of the pinion
assembly and allow fine manual
focus when the motor is disengaged.
Coarse manual focus can usually be
accomplished by disengaging the
motor and adjusting the black focus
knob on the opposite side of the
focuser.
FocusLynx FT Model
Be sure you have the correct size
QuickSync Ft motor assembly for
your focuser. Review the table
below if there is any doubt as to which model FeatherTouch or QuickSync motor assembly you possess.
FeatherTouch Model
FTF20xx series
FTF25xx series
FTF27xx series
FTF30xx series
FTF35xx series
AP series scopes
FTM-xxx series
MPA-xxx
Telephone: 616-897-9351 · Fax: (616) 897-8229 · Toll Free: 888-488-0381
FocusLynx FT with QuickSync
Nominal Drawtube Size
2-inch
2.5-inch
2.7-inch
3-inch
3.5-inch
4.0-inch
n/a – Feather Touch
Micro replacement for
SCT standard focuser.
Micro Pinion Assembly
199 Smith Street · Lowell, Michigan 49331 · U.S.A.
sales@optecinc.com http://www.optecinc.com
·
FocusLynx QuickSync Installation Instructions - Revision 2
Housing / Shaft Dia.
1.000" / 0.109" (7/64")
1.330" / 0.156" (5/32")
1.330" / 0.156" (5/32")
1.330" / 0.156" (5/32")
1.460" / 0.156" (5/32")
1.460" / 0.156" (5/32")
1.000" / 0.109" (7/64")
varies
www.optec.us
·
FocusLynx FT Model
QuickSync FT20
QuickSync FT30
QuickSync FT30
QuickSync FT30
QuickSync FT40
QuickSync FT40
QuickSync FT20
Contact Optec
Page 1 of 10