BBQ Guru CYBERQ Faq & Troubleshooting

1.FAQ / Troubleshooting
1.1.My Computer shows I am connected to the CyberQ WiFi, but can't I view the webpages?
1. If you are in adhoc mode, only one client is allowed access at a time. To get access, reset the
CyberQ WiFi by holding down the MODIFY/ENTER Key and try again from the new client.
2. Double check the CyberQ WiFi's ip address.
3. Interference - Other 2.4GHz such as cordless phones and wireless networked devices may cause
interference with the CyberQ WiFi and prevent a reliable connection. It is the customer's responsibility
to diagnose the source of the interference and determine which devices need to be turned off or
eliminated from the installation.
1.2.How do I change the Name (SSID) and Password (KEY) for my CyberQ WiFi?
There are two methods; from the web interface or from the front panel keys.
Web Interface:
1. Connect using adhoc mode, enter the CyberQ's IP address in your browser.
2. Click on the WiFi setup tab.
3. Change the SSID and the KEY entries.
4. Press and hold the MODIFY/ENTER key on the front panel to reset.
Front Panel Keys:
1. Hold down UP and DOWN until SYSTEM SETUP is displayed.
2. Press RIGHT until you see WIFI SETUP.
3. Press DOWN until SSID is displayed.
4. Press MODIFY/ENTER to modify the SSID. Adjust the value using the UP/DOWN and
LEFT/RIGHT. When you done changing the value, press the MODIFY/ENTER.
5. Press DOWN until KEY is displayed.
6. Press MODIFY/ENTER to modify the SSID. Adjust the value using the UP/DOWN and
LEFT/RIGHT. When you done changing the value, press the MODIFY/ENTER.
7. Press and hold all 4 arrow keys to reset.