Advertisement
Installation
Determine the location where you would like to install the Series 300 Y | SHELF ™.
•
Place the shelf at the desired location on the substrate and mark along the outer edges of the shelf which are
•
in contact with the wall.
Place the template along the markings and make new ones for the holes along the perforations.
•
Drill a 15/64" diameter hole on these markings. Insert the plastic anchors supplied along with the screws.
•
Prepare the included Y | BOND™ by mixing the resin and hardener in equal parts.
•
•
Spread the prepared Y | BOND™ resin and hardener along the edges of the shelf which will be in contact with
the wall after installation.
•
Slide in the Series 300 Y | SHELF™ along the horizontal profile on the screws on one wall and push to the
perpendicular wall till the shelf rests on the screws. Place weight over the shelf(approx.4 lbs) and secure the
shelf with tape
Remove weights and tape after a period of 8 hours. The Y | BOND™ cures fully after a period of 24 hours. Use
•
silicone caulk along the edges to waterproof.
Care & Maintenance
•
Neelnox recommends 3M Stainless steel cleaners or a damp soft cloth, mild dishwashing soap and a
non abrasive sponge if required. Always clean along the direction of the grain. Do not use acid or
corrosive solutions, chloride solutions, abrasive pads or steel wool for cleaning.
Y | S H E L F SERIES 300 INSTALLATOIN INSTRUCTIONS
Page | !/!
2 2
Advertisement
