Solar Centre Everbright Solar Lights User Manual

EVERBRIGHT
s o l a r
User Guide
Thank you for choosing our Everbright Solar Lights, Solar Rattan Lights, Solar Hessian Lights, Solar Party Lights or Solar Chinese
Lights. Please read these instructions carefully before using them.

Box Contents:

Solar panel module, LED Light string, stake mount, extension shaft, multimount, USB charging cable, extension cable, screw and
Rawl plug pack

Setting up your lights

Always take care when setting up your
Everbright Solar Lights especially when
you are situating them in high places. In
the interest of safety, we strongly advise
setting up your solar lights during the
day while it is still light. Children should
only set up the lights with the
assistance and careful supervision of a
responsible adult.
Choosing your location:
Before setting up your Everbright Solar
Lights you'll need to think about the
location of the solar panel module. Your
solar panel module needs to be in an
unshaded location where light is not obstructed by buildings, walls, fences, trees, bushes or the shadows that these create. You will
need to rethink your location if your solar panel module can't reach a bright and unobstructed location. If you are in any doubt
please check before installing your lights. Once you are happy with your solar panel module location, install it by following the guide
below. Once your solar panel module is installed, you can unravel your lights and place them where you like.

Stake Mounting

Before attempting to push the stake into the ground, please check that the
ground is not too hard as any damage caused to your solar panel module as a
result of driving them into hard ground is not covered by your warranty. If the
ground is too hard, pour water on the desired area to soften the ground and make
a hole using a strong metal object before driving your stake into the hole. Almost
all of the stake needs to be under ground with only the piece above the ridge being
above ground (see right). Now your stake is in place, locate the extension shaft
and twist it onto the stake mount. The extension shaft is designed to keep the
solar panel module off the ground to prevent water ingress.

Multimount for wall, fence and deck mounting

Attach the multimount to your wall, fence or decking using the supplied screws
and Rawl plugs. Now your wall mount is in place, locate your solar panel module and
gently push it onto the wall mount until it is fully inserted and secure. Please do
NOT use the extension shaft in conjunction with the multimount as this setup
will not be secure and may cause injury or damage in high winds or other
scenarios. The extension shaft is for use with the stake mount only.

Operating Instructions

The Everbright Solar Lights are fully automatic so once turned on they will come on
automatically at night and turn off automatically at dawn unless you turn them off at
the switch. To turn your Solar Lights on simply press the power button on the
underside of the solar panel.

Lighting Modes:

There are 8 modes available on your Everbright Solar Lights and 2 modes on your
Everbright Solar Party, Rattan, Hessian and Chinese Lights. To change modes
press the Mode button on the underside of the solar panel.
l i g h t s
TM

Solar Charging Tips

Do:
N
W
S
Don't:
Ensure your solar
panel is South facing
E
or as near as possible
Do NOT place your
solar panel shaded
areas.
simply
Clean your solar
panel from time
to time
1: Stake Mount 2: Extension shaft
Ridge
3: Multimount
Do NOT charge
behind glass