Revere HSR Installation Instructions Manual

HSR FRONT BUMPER INSTALLATION
______________________________________________________________
NOTICE: Please read all instructions carefully before beginning fitment or painting.
______________________________________________________________
 Revere does not accept any claims of loss or damages caused by the tools or process conducted while working on the vehicle.
 Claims of any sort on the product post-paint procedure will not be accepted.
 Any and all inquiries of claims on the product must be made within 1 week of receipt of the product.
 Prior to painting the parts or making such modifications such as drilling holes, please pre-fit the parts onto the intended vehicle. If there are any
fitment discrepancies at this point please contact your vendor or Revere London head office immediately.
DRYING TEMPRATURE NOTIFICATION: Revere recommends that any products which require painting are air-dried under a very low
temperature, (below 40'c). Since the product is made from plastic Revere recommends the products are supported in a correct manor while
being painted. (Improper support may result in the product becoming twisted or rippled).
WARNING NOTIFICATIONS

Because of the materials used in construction of the products they may have sharp edges, please take all precautions.
 Please read in entirety and proceed only with full understanding of the contents.
 Improper installation may lead to the product failing during moving of the vehicle and may cause injuries or property damage.
 Please make periodic maintenance checks on the fixtures to make sure they have not been damages or loosened.
 Please follow the steps from the factory service manual when removing the factory items.
 If any parts damaged , please take time to remove the item prior to driving the vehicle.
 If any modifications are made to the chassis, such as drilling for holes, please make rust preventative actions.

Please do not have the vehicle washed at automated car washes.
 Please do not over tighten the bolts, nuts, brackets as this may lead to premature breaking of the products.

The proper maintenance of a vehicle is the responsibility of the driver under the LAW. Make daily and periodic preventative maintenances.
 In the event that a claim is reported after the parts have been modified or painted, those claims will not be accepted.
 Prior to painting the parts or making such modifications such as drilling holes, please pre-fit the parts onto the intended vehicle. If there are any
fitment discrepancies at this point please contact your vendor or Revere London head office immediately.
Product warnings and notifications are subject to change, please refer to reverelondon.com for the most up-to-date notifications and fitting information.
Notice: The Revere HSR Rear Bumper removes the use of the tow eye.
2005-2009 Model Year
RANGE ROVER SPORT
Last Updated: March 2010
www.reverelondon.com
Please take caution while handling products and tools.