SonTek RS5 Quick Start Manual

RS5 - Quick Start Guide
Getting started with the RS5 System
This is a quick reference guide to get started with the
RS5 system. For more detailed information, refer to the
User Manual which can be found on the USB drive
included with the system or via the Manual button in the
RSQ software. It is highly recommended that you review
the manual. <Ctrl> + click on a section in the table of
contents will take you directly to that section. Also, it is a
PDF and easily searchable.
What's in the Case?
RS5 Standard System
A
RS5 Max GNSS System
G
A
B
C
G
Standard Components
A RS5
B (2) Li-Ion rechargeable batteries
Li-Ion Battery Charger and AC/DC wall adapter,
C
USB
D SonTek Bluetooth USB radio
E (2) Bluetooth radio antenna
USB flashdrive, software and manual
F Warranty registration card
Max Components – components above plus below
G GNSS smart antenna
H Cable: RS5-GNSS antenna
Windows Software Installation
Install the RSQ software from the included USB drive or
download and install from
https://www.sontek.com/software-downloads
1
B
D
E
B
D
E
D E
H
RS5 – Quick Start Guide: Getting started with the RS5 System
Getting Started – Hardware setup
 Charge both included Lithium Ion batteries by
connecting the battery charger to the AC/DC power
supply via the USB connector.
 Install a charged battery into the RS5 with the positive
terminal facing down into the compartment. LED light will
start flashing white quickly then red to indicate system is
powered on and in Stand-by mode ready for connection.
 Connect supplied antenna cable to radio antenna, and
antenna cable to RS5 connector labeled with a Bluetooth
icon.
 Mount radio antenna on antenna mast.
 If equipped with GNSS, mount GNSS antenna on
antenna mast and then connect to RS5 using supplied
RS5-GNSS cable.
 Connect USB radio to USB port; the light will start
blinking green indicating the radio is powered and
change to blinking blue once successfully connected to
an RS5.
Getting Started – Software setup and
connection
 Open RSQ software
 First time only –specify data directory to save
measurements. Click on Tools icon and then choose
Settings:
 Click on the [folder] icon to the right of the blank field
Data storage location and choose where you want to
save measurement files.
 Click on the Connect button
 Click Connect then enter your RS5 serial number in the
format RS5-###. Example below:
P/N 45-0189 Rev A