Advertisement
Advertisement
Table of Contents
Summary of Contents for Dakota POWERBOX 10
- Page 1 INSTRUCTION GUIDE...
- Page 2 GETTING STARTED • For safety your new Powerbox 10 ships with the battery partially disconnected. • Before first use open the Powerbox using the latch on the left end. • The negative wire to the battery is disconnected. • Connect the black wire to the negative (-)(black) terminal.
- Page 3 MASTER POWER SWITCH 12V POST TERMINALS LED / FL ASHLIGHT 12V CAR PLUG 12V POST SWITCH TERMINAL SWITCH DUAL USB PORTS / VOLTMETER...
- Page 4 • Insert the silver pins into the tops of the POST TERMINALS • Activate POST TERMINAL SWITCH on Powerbox 10 • Clamp the RED clip to the silver pin in the RED POST • Clamp the BLACK clip to the silver pin in the BLACK POST •...
- Page 5 DUAL USB PORTS / VOLTMETER • Activate MASTER POWER SWITCH • The Dakota Lithium LED namplate will light up, indicating power is active • Flip up rubber port cover of DUAL USB PORTS / VOLTMETER • Note VOLTMETER voltage readout, which confirms...
- Page 6 LED / FL ASHLIGHT USE • Activate MASTER POWER SWITCH • The Dakota Lithium LED namplate will light up, indicating power is active • Activate LED / FLASHLIGHT POWER SWITCH • LED FLASHLIGHT is now active and ready for use 12V CAR PLUG USE •...
- Page 7 POST TERMINAL USE • Activate POST TERMINAL SWITCH • POST TERMINALS are now active for use NOTE: The Powerbox is charged through the POST TERMINALS NOTE: POST TERMINALS are on a separate circuit, and do not require the MASTER POWER SWITCH to be active FUSE REPL ACEMENT •...
- Page 8 JOIN THE DL COMMUNITY...
Need help?
Do you have a question about the POWERBOX 10 and is the answer not in the manual?
Questions and answers