Table of Contents
Advertisement
Quick Links
1. Scope
This instruction manual describes how to replace the battery in your PAGM infrared gas leak detector. It is assumed that
the user is familiar with the device.
information for each PAGM model.
WARNING: Failure to comply with these instructions may void the warranty.
2. Items Required
•
Original PAGM instruction manual (optional)
•
Replacement Battery Kit (3015-5743)
o
Rechargeable lithium-ion battery (colors may vary)
o
Cable with 2.1 mm jack (for newer series PAGMs)
o
Cable with 2.5 mm jack (marked in red, for older series PAGMs)
o
Battery charger
o
This instruction manual
NOTE: The 2.1 mm and 2.5 mm cables look very similar. For easy identification, the cable with the 2.5 mm
plug is marked in red. Note that this cable is used for certain older series PAGMs.
3015-5744 Rev 1
1.800.561.8187
Battery Replacement Kit
for Portable Area Gas Monitors (PAGMs)
Instruction Manual
If necessary, refer to the instructions for detailed operation and maintenance
www.
information@itm.com
.com
1
Advertisement
Table of Contents
Summary of Contents for Bacharach 3015-5743
- Page 1 2. Items Required • Original PAGM instruction manual (optional) • Replacement Battery Kit (3015-5743) Rechargeable lithium-ion battery (colors may vary) Cable with 2.1 mm jack (for newer series PAGMs) Cable with 2.5 mm jack (marked in red, for older series PAGMs)
- Page 2 Battery Replacement Kit for Portable Area Gas Monitors 3. Charging the New Battery The lithium-ion battery in your kit will likely be partially charged when you receive it. However, you should fully charge the battery prior to operating the PAGM. Charging Step Charging the New Battery...
- Page 3 Battery Replacement Kit for Portable Area Gas Monitors Removing the Old Battery Step Removing the Old Battery Open the soft case at the top of the PAGM unit by pulling apart the Velcro fasteners and folding back the soft case to expose the top of the PAGM enclosure. Locate the part number sticker (3015-xxxx).
- Page 4 Battery Replacement Kit for Portable Area Gas Monitors Step Selecting the Appropriate Battery Cable Compare your PAGM’s part number (from earlier in this instruction) with part numbers 3015-5696 and 3015-5420. If your PAGM is neither 3015-5696 nor 3015-5420, then use the cable with the 2.1 mm jack. Discard the incorrect cable, then proceed to “Installing the New Battery.”...
- Page 5 Battery Replacement Kit for Portable Area Gas Monitors Step Installing the New Battery Connect the 90-degree plug into the battery pack connector on the side of the PAGM enclosure. Loosely pack any excess cable into the battery pocket, being careful not to stress the connection points. Close the zipper on the battery pocket.
Need help?
Do you have a question about the 3015-5743 and is the answer not in the manual?
Questions and answers