Power Requirements; Connections And Operation - iSP Technologies HUM EXTRACTOR +DECIMATOR G Owner's Manual

POWER REQUIREMENTS

This unit requires the connection of the external AC Power Adaptor to a 120 volt AC outlet. Do
not attempt to connect this unit to any power source other than the one supplied with the HUM
EXTRACTOR +DECIMATOR G. The HUM EXTRACTOR +DECIMATOR G will typically draw on
the order of 800 milliamps of current from the AC power adaptor when in use.

CONNECTIONS AND OPERATION

Refer to the Figures shown below which show the locations of the switches, knobs, and jacks
when reading the following, or even better, just look at your unit.
Connect the supplied 9V AC power adaptor to wall power, then to the POWER input on the HUM
EXTRACTOR +DECIMATOR G. The unit will power up and automatically recall the last used
settings.
The unit has two channels with INPUT and OUTPUT connections. Plug the guitar directly into the
input of Channel 1 and connect the output of Channel 1 to the input of your rig. You can select
the position for the HUM EXTRACTOR function to be inserted into channel 1 or channel 2 via the
HX POS switch. For most setups selecting channel 1 may provide better transparency however,
this allows you to select the HUM EXTRACTOR function to be before or after the distortion block
of your setup. Select this position for the best operation of your particular system. In order for the
HUM EXTRACTOR +DECIMATOR G to function properly the direct guitar input signal needs to
be inserted into channel 1, this allows the direct guitar signal to be used to control the level
detection for both the HUM EXTRACTOR and the DECIMATOR functions.