Page 1
NOTE: This Operator’s Manual covers several models. Features may vary by model. Not all features in this manual are applicable to all models and the model depicted may differ from yours. MTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 Printed In USA Form No.
How-To video; you can seek help from the experts. Have your full model number and serial number ready. Choose from the options below: Web: www.mtdproducts.com/equipment/mtdproducts ◊ ◊ Phone: (800) 800-7310 ◊ Mail: MTD LLC • P.O. Box 361131 • Cleveland, OH • 44136-0019...
Important Safe Operation Practices WARNING! This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
Children Never allow children under 14 years of age to operate this machine. Children 14 and over should read and understand Tragic accidents can occur if the operator is not alert to the the instructions and safe operation practices in this manual presence of children.
Assembly & Set-Up Contents of Carton Hardware & Loose Pack Items Figure 3-1 Ref. Ref. Part Number Description Qty. Part Number Description Qty. 683-05220 Front Canopy Mount Plate 749-05389A Rear Support 736-0451 Sdle. Wash., .320 x .930 x .060 749-05387 Rear Right Support 712-04063 Flange Lock Nut, 5⁄16-18...
Page 6
NOTE: All references to LEFT, RIGHT, FRONT, and REAR indicate Before installing the front right support (#6A), the oil drain tube the Snow Cab/Sun Shade position when sitting in the tractor seat and clip must be removed from the frame. See Figure 3-3. The in the operator’s position.
Page 7
Use two flange lock nuts (#10), two saddle washers (#9), two flat washers (#13) and two hex screws (#14) to mount NOTE: If you purchased the Snow Cab Kit (19A30022100) alone, the the rear support (#1) to the frame of the tractor as shown in Sun Shade attachment (790-00710) can be ordered separately.
Page 8
Installing the Snow Cab The rear center clip clips onto the center of the fender. See Figure 3-11. NOTE: If you purchased the Sun Shade kit (Part #19A30021100) alone, you can order the Snow Cab attachment (790-00712) seperately. NOTE: To help remove any wrinkles in the snow cab, leave the snow cab unfolded out in the sun.
Page 9
The outer front clips attach to the front fenders near the Unzip the cab door and locate the five straps inside the wheels. See Figure 3-13. cab. There is one in the front (near the hood) and a four along the top. Snap the ends of each strap together and then tighten them securely.
Page 10
Secure the two velcro tabs on the back corners of the snow The lift handle and trigger control can be accessed by cab to ensure a tight fit. See Figure 3-17. unzipping the right side of the snow cab. See Figure 3-19.
Page 11
Align template A on the right side of the tractor as shown in secure in place with the hex screw, nut and screw from the Snow Cab/Sun Shade Mounting Kit. See Figure 3-21. Figure 3-21 Drill the appropriate holes with the 9⁄32” drill bit provided in the Snow Cab/Sun Shade Mounting Kit.
Page 12
MANUFACTURER’S LIMITED WARRANTY FOR The limited warranty set forth below is given by MTD LLC with Routine maintenance items such as lubricants, filters, blade respect to new merchandise purchased and used in the United sharpening, tune-ups, brake adjustments, clutch adjustments,...