Related Manuals for Raymarine RCR-1
Summary of Contents for Raymarine RCR-1
- Page 1 RCR-1 MicroSD CARD READER Installation instructions English (en-US) Date: 10-2020 Document number: 87396-2 © 2020 Raymarine UK Limited...
- Page 3 Software updates Check the Raymarine website for the latest software releases for your product. www.raymarine.com/software Product documentation The latest versions of all English and translated documents are available to download in PDF format from the website: www.raymarine.com/manuals.
-
Page 5: Table Of Contents
7.1 General cabling guidance ....................24 Cable types and length......................24 Cable routing ........................24 Strain relief..........................24 Cable shielding ........................24 Suppression ferrites......................25 Fitting suppression ferrites ....................25 7.2 Connections overview ...................... 26 Using the RCR-1 with cartography ..................26 Network connection to multiple MFDs .................27... - Page 6 8.3 Removing MicroSD card from its adaptor ..............30 8.4 Inserting MicroSD card into reader .................. 31 8.5 Removing MicroSD card from reader ................31 8.6 Using the RCR-1 with cartography..................31 Chapter 9 Maintenance ....................33 9.1 Service and maintenance....................34 9.2 Routine equipment checks ....................
-
Page 7: Chapter 1 Important Information
Raymarine. Raymarine is not responsible for damages or injuries caused by your use or inability to use the product, by the interaction of the product with products manufactured by others, or by errors in information utilized by the product supplied by third parties. -
Page 8: Declaration Of Conformity
EMC performance throughout the installation. Declaration of Conformity FLIR Belgium BVBA declares that the RCR-1, part number A80585, is in compliance with the EMC Directive 2014/30/EU. The original Declaration of Conformity certificate may be viewed on the relevant product page at www.raymarine.com/manuals. -
Page 9: Imo And Solas
In addition, our policy of continuous product improvement may change specifications without notice. As a result, Raymarine cannot accept liability for any differences between the product and this document. Please check the Raymarine website (www.raymarine.com) to ensure you have the most up-to-date version(s) of the documentation for your product. -
Page 11: Chapter 2 Product And System Overview
Chapter 2: Product and system overview Chapter contents • 2.1 Document information on page 12 • 2.2 Applicable products on page 12 • 2.3 Product overview on page 12 Product and system overview... -
Page 12: Document Information
The card reader has a waterproof rating of IPx6 / IPx7 (when lid is closed). Note: Most MicroSD cards are supplied with an adaptor; MicroSD cards must be removed from their adaptors before they can be used in the RCR-1’s MicroSD card slot. For more information refer 8.3 Removing MicroSD card from its adaptor Compatible displays The RCR–1 card reader is compatible with the following LightHouse™... -
Page 13: Chapter 3 Parts Supplied
Chapter 3: Parts supplied Chapter contents • 3.1 Parts supplied on page 14 Parts supplied... -
Page 14: Parts Supplied
3.1 Parts supplied 1x RCR-1 microSD card reader, including 1 m (3.28 ft) captive cable. 2. 1x foam gasket. 3. 1x lock ring. 4. 1x suppression ferrite. -
Page 15: Chapter 4 Product Dimensions
Chapter 4: Product dimensions Chapter contents • 4.1 Product dimensions on page 16 Product dimensions... -
Page 16: Product Dimensions
4.1 Product dimensions * 29 mm (1.14 in) diameter cut-out hole required. -
Page 17: Chapter 5 Location Requirements
Chapter 5: Location requirements Chapter contents • 5.1 Switch off power supply on page 18 • 5.2 Potential ignition source on page 18 • 5.3 Location requirements on page 18 • 5.4 EMC installation guidelines on page 18 Location requirements... -
Page 18: Switch Off Power Supply
This product is NOT waterproof when the lid is open. 5.4 EMC installation guidelines Raymarine equipment and accessories conform to the appropriate Electromagnetic Compatibility (EMC) regulations, to minimize electromagnetic interference between equipment and minimize the effect such interference could have on the performance of your system Correct installation is required to ensure that EMC performance is not compromised. -
Page 19: Chapter 6 Installation
Chapter 6: Installation Chapter contents • 6.1 Flush mounting on page 20 • 6.2 Surface mounting on page 21 Installation... -
Page 20: Flush Mounting
Important: For CNC machining CAD data is available on the Raymarine website. 7. Ensure that the unit fits into the removed area and then remove rough edges. 8. Attach the gasket to the rear of the card reader. -
Page 21: Surface Mounting
6.2 Surface mounting When surface mounted the product protrudes slightly from the mounting surface, usually by the thickness of the bezel. 1. Check the selected location for the unit. A clear, flat area with suitable clearance behind the panel is required. 2. -
Page 23: Chapter 7 Connections
Chapter 7: Connections Chapter contents • 7.1 General cabling guidance on page 24 • 7.2 Connections overview on page 26 Connections... -
Page 24: General Cabling Guidance
• Unless otherwise stated only use cables supplied by Raymarine. • Where it is necessary to use non-Raymarine cables, ensure that they are of correct quality and gauge for their intended purpose. (e.g.: longer power cable runs may require larger wire gauges to minimize voltage drop along the run). -
Page 25: Suppression Ferrites
Suppression ferrites • Raymarine cables may be pre-fitted or supplied with suppression ferrites. These are important for correct EMC performance. If ferrites are supplied separately to the cables (i.e. not pre-fitted), you must fit the supplied ferrites, using the supplied instructions. -
Page 26: Connections Overview
Due to the high data bandwidth requirements of electronic charts (especially when sharing with other networked MFDs), Raymarine recommends that an MFD internal card reader is used for cartography whenever possible. If the RCR-1 is used for cartography, you must first fit suppression ferrites; for more information refer to: p.25 — Fitting suppression ferrites... -
Page 27: Network Connection To Multiple Mfds
Network connection to multiple MFDs The RCR-1 can read electronic chart data from a MicroSD card. The cartography can be shared to multiple MFDs connected on the same network. RCR-1 2. 1 m (3.28 ft) captive cable (Micro USB) 3. Axiom XL MFD providing power over Micro USB 4. -
Page 29: Chapter 8 Operation
8.3 Removing MicroSD card from its adaptor on page 30 • 8.4 Inserting MicroSD card into reader on page 31 • 8.5 Removing MicroSD card from reader on page 31 • 8.6 Using the RCR-1 with cartography on page 31 Operation... -
Page 30: Compatible Microsd Cards
8.1 Compatible MicroSD cards MFD supported Type Size Native card format Format MicroSDSC (Micro Secure Up to 4GB FAT12, FAT16 or NTFS, FAT32 Digital Standard Capacity) FAT16B MicroSDHC (Micro Secure 4GB to 32GB FAT32 NTFS, FAT32 Digital High Capacity) 32GB to 2TB exFAT NTFS, FAT32 MicroSDXC (Micro Secure... -
Page 31: Inserting Microsd Card Into Reader
Due to the high data bandwidth requirements of electronic charts (especially when sharing with other networked MFDs), Raymarine recommends that an MFD internal card reader is used for cartography whenever possible. If the RCR-1 is used for cartography, you must first fit suppression ferrites; for more information refer to: p.25 — Fitting suppression ferrites... -
Page 33: Chapter 9 Maintenance
Chapter 9: Maintenance Chapter contents • 9.1 Service and maintenance on page 34 • 9.2 Routine equipment checks on page 34 Maintenance... -
Page 34: Service And Maintenance
9.1 Service and maintenance This product contains no user serviceable components. Please refer all maintenance and repair to authorized Raymarine dealers. Unauthorized repair may affect your warranty. 9.2 Routine equipment checks It is recommended that you perform the following routine checks, on a regular basis, to ensure the correct and reliable operation of your equipment: •... -
Page 35: Chapter 10 Technical Support
Chapter 10: Technical support Chapter contents • 10.1 Raymarine product support and servicing on page 36 • 10.2 Learning resources on page 37 Technical support... -
Page 36: Raymarine Product Support And Servicing
You can obtain this product information using diagnostic pages of the connected MFD. Servicing and warranty Raymarine offers dedicated service departments for warranty, service, and repairs. Don’t forget to visit the Raymarine website to register your product for extended warranty benefits: http://www.raymarine.co.uk/display/?id=788. United Kingdom (UK), EMEA, and Asia Pacific: •... -
Page 37: Learning Resources
Russia (Authorized Raymarine distributor): • E-Mail: info@mikstmarine.ru • Tel: +7 495 788 0508 10.2 Learning resources Raymarine has produced a range of learning resources to help you get the most out of your products. Video tutorials Raymarine official channel on YouTube: • YouTube LightHouse™... -
Page 39: Chapter 11 Technical Specification
Chapter 11: Technical specification Chapter contents • 11.1 Technical specification on page 40 • 11.2 Compliance on page 40 Technical specification... -
Page 40: Technical Specification
11.1 Technical specification Environmental specification -25 ºC to +55 ºC (-13 ºF to 131 ºF) Operating temperature Storage temperature -30 ºC to +70 ºC (-22 ºF to 158 ºF) Relative humidity Maximum 93% Waterproof rating IPx6 & IPx7 (lid closed) Power Power consumption 5 V dc... - Page 43 Index Routine checks ............34 Cable Bend radius............24 Protection ............24 Service Center............36 Routing ..............24 Servicing..............34 Security ..............24 Support forum ............37 Strain relief............24 Suppression ferrites ..........25 Compatibility Surface mounting ............ 21 MicroSD card ............30 Compatible MFDs............ 12 Connections ............26 General cabling guidance........24 Technical specification ........
- Page 46 Raymarine Marine House, Cartwright Drive, Fareham, Hampshire. PO15 5RJ. United Kingdom. Tel: +44 (0)1329 246 700 www.raymarine.com a brand by...
Need help?
Do you have a question about the RCR-1 and is the answer not in the manual?
Questions and answers