Do you have a question about the ID131Color HR and is the answer not in the manual?
Questions and answers
Summary of Contents for Letsfit ID131Color HR
Page 1
Fitness Tracker User Manual ID131Color HR Thank you for purchasing our products. This manual addresses the safety guidelines, warranty and operating instructions. Please review this manual thoroughly before operating your device.
SAFETY AND WARRANTY Important Safety Instructions The device contains electrical equipment that may cause injury if not used properly. For example, prolonged contact may contribute to skin allergies for some users. To reduce irritation, please read the safety guidelines on the following pages to ensure proper use and care.
Page 3
● For light colored arm bands, minimize direct contact with dark-colored clothing, as color transfer could occur. ● Dispose of this device, the device’s battery and its package in accordance with local regulations. ● Don’t not check any notifications, GPS, or any information on your device’s display while driving or in other situations where distractions could cause injury or hazardous.
Page 4
● While the optical wrist heart rate monitor technology typically provides the best estimate of a user's heart rate, there are inherent limitations with the technology that may cause some of the heart rate readings to be inaccurate under certain circumstances, including the user's physical characteristics, fit of the device, and type and intensity of activity.
● If your bands get wet—like after sweating or showering—clean and dry them thoroughly before putting them back on your wrist. ● Be sure your skin is dry before you put your bands back on. Warranty We strives to build our products with the highest attention to detail and craftsmanship.
Page 6
Fitness Tracker Activation Please charge your tracker for at least 10 minutes to have it activated before initial use. Gently pull the bands off Insert the built-in USB plug the tracker body following with metal pins into a USB the direction of the arrow. charger for charging.
Assemble and Wear the Fitness Tracker Assemble: Push the bands in the tracker body. Wear: Wear the tracker on your wrist horizontally, about 2cm to carpal, the same way as wearing a watch. App Installation Use the tracker with our customized app "VeryFitPlus". You can download "VeryFitPlus"...
Page 8
Notes: ● "VeryFitPlus" app is only compatible with smartphones, not tablets or PCs. ● Smartphones should have iOS 8.0 or higher/Android 4.4 or higher systems, Bluetooth version should be 4.0 or higher. App Interfaces Main Page Details...
Page 10
Pair the Device with Your Phone 1. Enable the Bluetooth of your phone. 2. Open "VeryFitPlus" app on your smartphone and go to "Me" page, tap the question mark on top of the page and tap "Hand Ring Products", then your smartphone starts searching devices.
Page 11
3. Choose "ID131Color HR" in the list of found devices, tap "ID131Color HR" to pair it with your smartphone. (If your phone failed to find ID131Color HR, please tap the touch key to wake the tracker, and search the device on your phone one more time.)
● If the tracker is unbound under connective state, the app will set the settings back to default and all data on the tracker will be cleared. If the tracker is unbound under disconnected state, the app will set the settings back to default, but the data on the tracker will not be cleared.
Page 13
You can set up to 3 different sports modes from 14 sports modes to display on the tracker screen (Go to "VeryFitPlus" app → "Me" page → "ID131Color HR" on top of the page → "More settings" → "Activity display").
Main Screen. Note: The screen brightness can be adjusted from Level 1 to Level 5 in "Me" page → "ID131Color HR" on top of the page → "More settings" → "Bracelet brightness" in the app and Level 5 is the brightest.
Tap the touch key to enter the next mode: Walk Mode. Note: "Alarm Mode" is available only when alarm alert(s) is/are added and turned on in the app (Go to "VeryFitPlus" app → "Me" page → "ID131Color HR" on top of the page → "Alarm Alert").
4. Walk Mode 1) Hold the touch key for 2s to start the walk mode. During exercise, tap the touch key to flip through exercise data. Steps Kcal Miles Pace AVG Pace Time 2) Hold the touch key for 2s to quit the walk mode. The following data is displayed after the exercise is ended: Steps/MI Min/Kcal...
Tap the touch key to flip through exercise data. 3) Tap the touch key to enter the next mode: Run Mode. Note: Data of exercises less than 1 minute will not be saved. 5. Run Mode 1) Hold the touch key for 2s to start the run mode.
2) Hold the touch key for 2s to quit the run mode. The following data is displayed after the exercise is ended: Steps/MI Min/Kcal AVG Pace/BPM Tap the touch key to flip through exercise data. 3) Tap the touch key to enter the next mode: Bike Mode. 6.
Page 19
2) Hold the touch key for 2s to quit the bike mode. The following data is displayed after the exercise is ended: Min/Kcal Tap the touch key to flip through exercise data. 3) Tap the touch key to go to the main screen. Notes: ●...
Page 20
Choose a sport Pause the sport GPS map Resume or stop the sport...
Page 21
6.1 Abnormal Situations During Exercise 1) Inactive Exit Prompt a. The tracker will automatically exit the sport mode if no action is taken in 15 minutes. b. The tracker will be forced to exit the sport mode if you don't tap on the waiting prompt within 15 seconds.
Notes: ● Only when "Call alert" is ON in the app, calls will be notified (Go to "VeryFitPlus" app → "Me" page → "ID131Color HR" on top of the page → "Call alert"). ● When "Non-disturb mode" is enabled in the app ("Me" page →...
Page 23
● Only when "Notifications Alert" is ON in the APP, messages will be notified (Go to "VeryFitPlus" app → "Me" page → "ID131Color HR" on top of the page → "Notifications Alert" → "Allow notification"). ● When "Non-disturb mode" is enabled in the app ("Me" page →...
Page 24
7.5 Target Completion Reminder When your goals are achieved, the tracker vibrates to remind you. 7.6 Device Error Notification When the tracker has an exception, an Error is displayed. Status code: -01 indicates the acceleration sensor is abnormal; -02 indicates the heart rate sensor is abnormal; -03 indicates the touch key IC is abnormal;...
Basic Specifications Model No.: ID131Color HR Battery Type: Lithium polymer battery Battery Capacity: 90mAh Working Voltage: 4.35V Sync: Bluetooth 4.0 Working Temperature: -20℃~ 40℃ Waterproof Rate: IP68 Working Time: up to 7days Host Weight: about 25g Declaration of toxic and hazardous substances in electronic information products The device meets the EU ROHS criterion.
Need help?
Do you have a question about the ID131Color HR and is the answer not in the manual?
Questions and answers