Hornbach 6196458 Manual page 36

Tubular motor
I. Description
1. Remote control 6196459 (not included)
2. Remote control 5637624, 6196477
(not included)
II. Circuit installation
1. Switch off.
2. Make sure the power supply matches the
specifications on the label A.
3. Connect the tubular motor to the main power
supply according to the diagram (see pic-
ture).
1:
Brown = L
2: Blue = N
3: Yellow/Green =
III. Setting extension limit
1. Switch on.
2. Press button to extend the awning to the
set limit (see Remote control: II. Pairing with
tubular motor).
3. To increase the expansion of the awning, in-
sert the special regulator into the red worm
and rotate in the "+" direction. Stop rotating
when the awning has reached the required
extension and press the stop button.
lV. Setting retraction limit
1.
Switch on.
2. Press button to retract the awning.
3. If the awning does not retract completely,
extend awning so that the special regulator
can be inserted into the white worm and
rotate in the "+" direction. Push button to
retract awning. Repeat until awning closes
satisfactorily.
36 EN
(Left foldout page)
3. Aerial
4. Power supply
5. Extension limit regulator
6. Tubular motor
7. Retraction limit regulator
Electrical work and repairs must be
performed by a qualified electrician.
4. Some models (e.g. 5637623) can be
plugged into a corresponding power outlet
(see Technical data).
4. To decrease the expansion of the awning,
press the stop button, rotate the red worm
in the "-" direction, fully retract the awning
and expand it again to the new limit. Repeat
until the awning reaches the required exten-
sion.
4.
If the motor still operates after awning is
completely retracted, rotate the white worm
in the "-" direction with the special regula-
tor. Ensure that the motor sound stops im-
mediately after awning is closed completely.