Advertisement
STEP 3. Attaching the interface bracket: (Illustration D) Remove one of the Keps nuts you finger tightened onto the drop brackets in step 2.
Hold the clinch stud in place from behind while you position the corresponding slot in the interface bracket onto the clinch stud, then
reinstall and hand tighten the Keps nut. (Note: the interface brackets have holes and slots closer to one edge than the other, the closer edge
is the top) Remove the keps nut from the opposite side drop bracket, hold the stud in place from behind while you position the
corresponding slot in the interface bracket onto the stud, reinstall and finger tighten the Keps nut (Note: Since the drop brackets where only
finger tightened in step 2 you should be able to rotate / swing them to allow easier installation of the interface bracket). With the interface
bracket in place and all the fasteners are finger tight, position the drop brackets as close to vertical / straight up & down as you can and then
tighten the keps nuts that attach them to the side table brackets. Now center the interface bracket left to right on the drop brackets and tighten
the remaining (2) keps nuts.
STEP 4. Attaching the Shelf Assembly: (Illustrations D & E) Position the shelf assembly over the ends of one of the interface bracket you
installed in step 3. The shelf brackets should fit over the outside of the interface bracket ends. Check the gap between the interface bracket
and the shelf brackets. You may need to slightly bend the interface bracket ends from side to side in order to achieve a small and parallel /
even gap between them, (the gap only needs to be wide enough to allow the shelf assembly to slide in and out freely to engage and
disengage the latching mechanism). When the gap is even, set the shelf assembly aside and insert a ¼" x 3/16" shoulder screw from the
outside inward through the inner hole (hole closest to the egg) at either end of the interface bracket, install an 8-32 nylock nut and tighten.
Repeat this at the inner hole in the opposite end of the interface bracket also. Position the shelf assembly over the interface bracket and insert
a ¼" x 3/16" shoulder screw through the slotted hole in the table bracket then through the outer hole in the interface bracket and install an
8-32 nylock nut. Repeat this at the slotted hole in the opposite side of the shelf assembly and tighten the nuts at both locations.
▲Always be certain both latches are engaged before use.
▲Do not place heavy objects on the shelves.
▲Do not sit or lean on shelves.
▲Do not place combustible materials on shelves while
charcoal is ignited.
Safety
3417 Lawrenceville Hwy. Tucker, GA 30084-5802
Phone: 770-938-9394 Fax: 770-938-9149 Website:
Illustration E
▲Do not let children sit, hang, swing, or pull them up on
the shelves.
▲Do not lift cooker by the shelves or brackets.
Use only on a stable & level surface.
▲
Big Green Egg
www.biggreenegg.com
Congratulations, you have completed the
installation of your Egg-Shelf. Simply
lift up the Shelf and slide it in or out to
engage or disengage the latch
mechanism. This product was designed
and manufactured in the U.S.A.
exclusively for Big Green Egg. Thank
you for your purchase.
Care & Cleaning
Clean the shelf surface with grease
fighting dish soap & warm water.
Household degreasers such as "409 or
Fantastic" may also be used. Do not use
abrasives or harsh cleaners as they may
permanently damage the surface.
Note: The shelves are molded from the
highest quality plastic materials
available, engineered specifically to be
durable and exceptionally heat resistant.
Please keep in mind, even the best
materials are not indestructible and very
hot items placed on the shelf surfaces
may permanently discolor or char the
surface.
5-30-08
2
Advertisement
