3D Fun Printz Pen Holder Manual

Cricut Maker/Air Explore series compatible Universal Pen Adapter
Most importantly. The Pen Holder is partly made from PLA as it is a natural plastic originating
from corn starch and is recyclable. For these reasons it does not like heat.
Please don't leave it in the sun, on a hot windowsill, on or near a radiator or anywhere else with
Please also keep away from children and animals. PLA can be sharp when broken.
NEVER TRY AND ADJUST THE SCREW WHILE THE HOLDER IS IN YOUR MACHINE. YOU
WILL DAMAGE YOUR MACHINE. ALWAYS FULLY REMOVE THE HOLDER BEFORE
DO NOT FLEX THE TIPS BY HAND. THEY ARE DESIGNED TO MOVE VERY SLIGHTLY TO
ACCEPT A PEN NIB. FORCING A PEN BODY ALL THE WAY THROUGH THE TIP OR
There are 2 pen holders in the kit. One is marked with an "S" and has a bigger opening for
pens. As a general rule of thumb if a pen fits in the non "S" holder you should use that one.
Only use the "S" holder if the pen is too big for the non "S" holder. This is especially
important on the Maker machine as the design prevents the common issue of pens rubbing
on the frame of the machine.
Thank you for purchasing the 3D Fun Printz Pen Holder
There are some tips below to get the best out of it.
FLEXING THEM BY HAND MAY BREAK THEM
a lot of heat.
ADJUSTMENT.