Page 1
GCLoader PNP Installation for DOL-101 & DOL-001 GameCube (All Regions) Tools Needed: • Gamebit 4.5mm security screwdriver (NTSC-U, PAL Units Only) Philips Screwdriver size no. 1 • Step 1 Remove the 4 security screws shown with arrows using a game bit driver. *Some consoles use normal Phillips screws.
Page 2
Step 3 Remove the two screws, unplug power cable and remove fan unit. Step 4 Remove all screws shown with arrows.
Page 3
Step 5 Remove Top DVD drive assembly. Step 6 Remove DVD drive from metal shield by removing all screws as shown. DOL-001 DOL-101...
Page 4
Step 7 Install the GCLoader with the supplied screws and washer. DO NOT overtighten. Put the washer where the large arrow is pointing. DOL-101 consoles will only use two screws. DOL-001 DOL-101 Step 8 Install the top metal shell back onto the gamecube. Now you can start re-assembly of your GameCube. Congratultions, you are done!