Advertisement
Quick Links
R
· Never allow children (or adults) to ride on or swing from garment rack
· Keep casters free of thread, lint, hair and other debris. Be sure casters turn easily and roll freely
at all times. If a caster does not roll properly, remove the garment rack from service immediately.
· Periodically check all nuts and bolts to ensure they are tight.
!
· Weight limit 175 lbs. — Do not overload!
· Be sure all loads are evenly balanced at all times. Overloading or unbalanced loads may cause
tipping, resulting in serious injury.
· Always proceed slowly and use extra caution when turning corners.
@
SALES
RBWIRE.COM
STEP
Install casters to upright legs by inserting caster
stems into bottom of legs. Insert bolts through side
with flush bolt holes, and secure with nuts on the side
with dimpled bolt holes.
STEP
Place crossbar (with warning label side facing up) onto
the side of the wheelbase with nuts. Align the three
vertical holes and secure with partial-thread bolts and
nuts, with nuts on underside. Then secure horizontal holes
with four partial-thread bolts. Nuts should be on the same
side as crossbar. Repeat for other side.
(800) 634-0555
ASSEMBLY INSTRUCTIONS
MODEL 715/721 and 722/725
Portable Garment Racks
TOOLS REQUIRED:
(2) 7/16 wrenches or sockets
2 person assembly suggested
1
2
715, 721 HARDWARE INCLUDED
x28 Nuts
x4 Full-thread bolts
RBWIRE.COM
(Not to scale)
x24 Partial-thread bolts
Advertisement
Related Manuals for R&B Wire Products 715
Summary of Contents for R&B Wire Products 715
- Page 1 ASSEMBLY INSTRUCTIONS MODEL 715/721 and 722/725 Portable Garment Racks TOOLS REQUIRED: (2) 7/16 wrenches or sockets 2 person assembly suggested STEP Install casters to upright legs by inserting caster stems into bottom of legs. Insert bolts through side with flush bolt holes, and secure with nuts on the side with dimpled bolt holes.
- Page 2 Portable Garment Racks pg 2 STEP Model 715/721: With upper horizontal crossbar resting and centered on top of uprights, align the three vertical holes at each end and secure with three partial-thread bolts and nuts, nuts on the underside. Then secure crossbar at each end with two partial-thread bolts and nuts through the two center holes, nuts on inside.
- Page 3 ASSEMBLY INSTRUCTIONS MODEL 715/721 and 722/725 Portable Garment Racks pg 3 Basket Shelf Accessory Installation: STEP Remove bolt and nut in center of lower crossbar at both ends. STEP Place one half of basket on top of lower crossbar so that hole in basket lines up with hole in center of crossbar at one end.