To reconnect your SmartBand using NFC
1
Android™ device: Make sure that the NFC function is turned on and that the
screen is active and unlocked.
2
Place the Android™ device over your SmartBand so that the NFC detection
area of each device touches the other.
and permanently in the Notification panel when a connection with the
SmartBand is active.
You can drag down the status bar to open the Notification panel and get quick access to
the SmartBand application and the Lifelog application.
I don't receive alarm notifications
•
The alarm notification function only works when your SmartBand is connected to
an Xperia™ device.
My sleep data wasn't logged
•
Check the mode of your SmartBand and make sure that it is in night mode.
To check which mode your SmartBand is in
•
Briefly press the power key. The notification lights switch between one lit
and two lit lights when your SmartBand is in night mode, and when it is in
day mode, the notification lights illuminate one by one, then all lights go
out.
•
Switch your SmartBand to night mode if it is in day mode.
To switch between day mode and night mode
•
Press and hold down the power key for two seconds.
Data about my activities is not
updated in the Lifelog application
•
Make sure that you wear the SmartBand on your dominant wrist when collecting
data.
•
Make sure that you have an active Internet connection to ensure the successful
synchronisation of data between your SmartBand and the Lifelog application on
your Android™ device. Also, remember that your SmartBand only stores data for
up to two weeks.
I don't receive any location data
•
Make sure that your Android™ device has an active Internet connection.
•
Make sure that you have enabled location services, GPS satellites and Google's
location service on your Android™ device.
appears briefly in the status bar
5