Intelight Astreet LED Installation And Operation Instructions

Safety
1.
The lighting fitting should be installed, repaired and maintained by a person with the appropriate
qualifications. Incorrect installation or tampering carries a risk of electric shock.
2.
Installation of the lighting fitting must be carried out in accordance with its purpose and these
instructions.
3.
When installing lamps in an open air, never connect power supply in wet conditions.
4.
During installation or maintenance, make sure that the power supply is disconnected.
5.
When connecting the lighting fitting to the power network , make sure that the power supply
parameters correspond to the rated power. Make sure to connect the protective conductor. After
connecting the lighting fitting is energized.
6.
Do not touch the device with wet or damp hands.
7.
In case of suspicion of damage to the electrical part of the device (ballast, power cord), do not use the
lighting fitting.
8.
The device should be mounted in such a way that enables natural heat dissipation.
9.
Periodical maintenance should be done in order to assure proper operations.
10.
The manufacturer does not guarantee proper operation and shall be not responsible for any damage
or injury resulting from installation, repair or maintenance performed in contrary to the instructions,
generally accepted principles of installation, occupational safety rules, intended use or when the
installation was performed by a person without appropriate permissions.
Protection of environment
1. Cardboard or paper elements of the packaging should sent for recycling paper or deposited of into a
container for paper waste, while plastic packaging into a container for plastic waste.
2. Obsolete lighting fitting must not be disposed of as household waste and should be delivered to a
special WEEE collecting point.
Guarantee
1. The guarantee is valid for 12 months from the date of purchase.
2. The guarantee shall not cover mechanical damage, damage caused by improper installation,
operation or modifications of the lighting fitting as well as changes occurring due to natural wear and
tear of the product.
3. The manufacturer reserves that it does not take responsibility for the improper operation of the lighting
fitting as a result of interference in the lighting fitting construction carried out by the user without
permission.
4. Application of the lighting fitting: streets, roads, etc.
Handling of obsolete equipment
Pursuant to the Act of 29 July 2005 on
waste electrical and
equipment and the Act of 24 April
2009 on batteries and accumulators,
the presented device, after use, due
to hazardous substances contained in
it, is subject to collection of waste
electrical and electronic equipment.
Detailed information
collection can be obtained from
municipal authorities.
KTM 97334 – Instruction ASTREET LED 20 / 30 / 40 / 50, EN, ver. 08062016
electronic
Intelight Sp. z o.o.
on WEEE
8, Rydygiera str.
01 -793 Warsaw, Poland
EXTERIOR LAMPS
ASTREET LED
Version: ASTREET LED
INSTALLATION AND OPERATION INSTRUCTIONS
Power supply Source Standard colours
Top - grey RAL 7045
230 VAC / 50Hz LED
Bottom - white RAL 9016
LED Total
Versions source lamp
power power
Astreet LED 20 14 W 18 W
Astreet LED 30 21 W 27 W
Astreet LED 40 28 W 36 W
Astreet LED 50 35 W 45 W
Dimensions and weights, all versions *
Length [mm] 468
Width [mm] 235
Height [mm] 104
Weight [kg] 5,0
* - without grip
Mounting IP Insulation
on poles rating class
Ø60 IP66 I