Advertisement
Parts and Assembly
The following parts make up the Back-Leg-Chest dynamometer: Body (face), Dial, Pointer,
Footstand (base), Grip and Chain. Locate all of these parts. When assembled, should look like dia-
gram and like photographs on previous page.
To assemble your unit:
1) Locate and remove contents from packaging.
2) Attach handle/chain unit to swivel on top of face by using adjustable chain link. Make chain short-
er by putting adjustable chain link higher on the chain. If chain is not long enough obtain additional
chain footage (stock number 12-0443). Unit is now ready for use.
Handle/Grip
Footstand/base
Testing Protocol
1. Subject should stand with both feet on base. (see picture on upper right corner of previous page)
2. Adjust chain to accomodate test protocol. Perform the test. Subject should lift in a gradual vertical
motion.
3. The pointer on the dial indicates the force exerted. Each test should consist of three trial meas-
urements. The result is the average.
Dinamómetros de espalda pierna pecho análogos 12-0403 BASELINE manual ingles www.viaindustrial.com
Chain
Nut-eye swivel
Pointer
Dinamómetros de espalda pierna pecho análogos 12-0403 BASELINE manual ingles www.viaindustrial.com
Body/Face
Dial
Back-Leg-Chest dynamometer in raised postion
Advertisement
