Configure Ports - BÄSSGEN QUATRIX Manual

QUATRIX
• Press ENTER to set „A" as Port A's address; an asterisk confirms
this.
• Press ESC to return to „PORT A".
• Press the lower Scroll button once; „PORT B" appears.
• Repeat the above procedure for Ports B-D, setting them to B, C, and
D, respectively.
Check the port configuration
• Press ESC again; „PROJECTORS <ABCD>" should appear now.
• If this is so, then press ESC repeatedly until „ADDRESS SELECT"
appears. If not, then repeat the above procedure.

Configure Ports

• Scroll through the Main Menu until „CONFIG PORTS" appears.
• Press ENTER to access the port configuration section; „PORT x"
appears x" appears whereby „x" refers to the output socket on the
QUATRIX.
• Scroll until „PORT A" appears.
• Press ENTER to access Port A's device configuration.
• Scroll until the desired port configuration appears; in our example
here you would want „EKTAPRO" to appear in the display.
The following table lists the possible settings available at this writing
and which devices belong each which category:
STANDARD1 Braun Paximat, Kindermann, Leitz, Rolleivision 66 AV
Seite 15