Infinite Transtector TEF14-C5-TE12 User Manual

TEF14-C5-TE12 User Manual
RJ45 Jacks (12)
Power Cords (2)
Mounting:
The TEF14-C5-TE12 is designed to mount into a standard 19" equipment rack, 3 rack spaces are required.
Power Requirements:
The TEF14-C5-TE12 contains (2) 120VAC/60Hz/600W power supplies to provide power to each of the 12
RJ45 ports. (2) 3-prong power cords are provided on the unit.
Note: A 15A breaker is recommended for each power input.
Installation With Enclosures:
The TEF14-C5-TE12 is designed to provide power to the heaters in up to 12 L-com TEF141207-4H0N
enclosures using CAT5 cabling. Heat output of the TEF141207-4H0N internal heater will vary with the length
of the CAT5 cable.
The heater resistance is 47 ohms. With zero cable loss at 48 VDC input, the heater generates 49 watts.
The heater and the heat generated by the enclosed equipment set the total. The TEF141207-4H0N uses all 8
wires in a CAT5 cable versus 4 wires used in standard 802.3af PoE. At 100m, the worst case loop resistance of
the CAT5 cable will be 4.8 ohms. Approximately 4W of heat will be dissipated in the cable and the heater output
will drop to 40 watts . If a long cable is used and the equipment mounted in the enclosure does not generate
sufficient heat, the TEF14-C5-TE12 injector output voltage can be adjusted higher to compensate. The maximum
voltage is 55 volts. This can be done at the factory prior to shipment.
The TEF14-C5-TE12 and TEF141207-4H0N enclosure uses a proprietary wiring pin out. The RJ45
connectors on the TEF14-C5-TE12 enclosure or the TEF141207-4H0N should never be
connected to any other manufacturers equipment. Transtector is not liable for any damage done
to incompatible equipment due to misuse of the TEF14-C5-TE12 or TEF141207-4H0N.
IP-00108 Rev. A – 06/10 Page 1/3
Copyright © 2019 This drawing is property of Transtector Systems Inc. All rights reserved.
Transtector Systems – 10701 N. Airport Drive – Hayden, ID 83835 USA
+1-208-635-6400 • www.transtector.com