Dino-Lite KM-01 User Manual

P/N:24101K1
KM-01 Knob Motor User Guide

NOTICE BEFORE ASSEMBLY

The KM-01 works with a certain range of Dino-Lite. If not certain whether the
Dino-Lite is compatible to the KM-01, please consult your reseller or distributor.
The KM-01 can work alone or work together with PC's using DinoCapture 2.0
software version 1.4.1 or newer.
Some Dino-Lite models have the ability to lock the knob to prevent it from
scrolling. Please make sure the knob is NOT locked to avoid damage to the knob
motor.

Package contents

Knob motor Control box
Power adapter USB 2.0 cable

Assembly instructions

1
align here
C-clip
Align and snap together the c-clip to Dino-Lite.

WRONG POSITIONS:

Covering the knob Slits facing up
C-clip Short / Long
handscrew
DinoCapture 2.0 Male / Female
CD 2 pin circular
DIN connector
Not aligned
2
Mount the c-clip onto the knob motor.
3
Power adapter
Knob motor
A. Plug in the power adapter and connect it to the control box.
B. Connect the knob motor to the control box.
NOTE:
An extension cable can be made for extending the distance between the knob
motor and the control box with a 0.5mm² x 2C cable and supplied 2 pin circular
DIN connectors. The recommended length of the extension cable should be
within 10 meters.
(Optional) Connect the USB cable to the control box and PC. The KM-01 Left/Right
C.
rotation control can then be controlled by either the control box or the DinoCapture
2.0 software. Additionally, the MicroTouch on the control box can trigger the
DinoCapture 2.0 software to take a picture.
Properly mounted
A
B C
USB 2.0
(Optional)
(User's computer)