Synergy Global Technology R2002 Quick Installation Manual

A. Introduction:

R2002 is a Riser Card, which changes the PCI card insert direction from vertical to horizontal and
also expands PCI slot up to two. In order to install the R2002
need to configure the mini-jumpers on R2002 by following the procedures in the next section
(Installation Procedures). For your convince, a device num
setting up the mini-jumpers and once the installation is done, R2002
system board. Which means you don't have to re-install or re-configure the R2002 while you are
operating (power-on/power-off) the system board.
In our lab testing, R2002 with full loading (two Ethernet LAN
very well and stable at maximum speed.

B. Installation Procedures:

1. Scanning the First Device Number

Step 1. Power-off system board. (Motherboard)
Step 2. Connect a PCI peripheral card into the first slot of R2002. The first slot is the one next to the R2002
card's golden finger. (See Fig. 1)
Step 3. Plug the above-prepared R2002 card into the system board.
Step 4. Power-on the system board and entering the DOS mode. Using a DOS system diskette in drive A
as the boot system is strongly recommended.
Step 5. In DOS prompt, execute the scanning software. The first slot's Device Number (DN#1) and other
PCI devices' DN# will be shown on screen. Keep these DN# for preceding the following steps.
Slot 2
Slot 1
R2002(
( 3 2 b i t 1
3 2 b i t 1
Q u i c k I n s t a
Q u i c k I n s t a
Fig. 1. PCI
. . . . . .
. . . . . .
. . . . . .
Page 1 of 1
- 2 R i s e r C a r d
- 2 R i s e r C a r d
l l a t i o n G u i d e
l l a t i o n G u i d e
on your system board (motherboard), you
ber scanning software is available as a tool for
could be treated as a part of your
cards loaded in all slots) performs
Mini-Jumper 2
)
)