Advertisement
Elmdene International Ltd
3 Keel Close, Interchange Park,
Portsmouth, Hampshire, PO3 5QD, UK
POE-MINIPOD
F
EATURES
The Elmdene POE-MINIPOD is a unique PoE+ powered device that can charge a 12V 7Ah battery whilst
continuing to provide a PoE compliant output (up to 14W) to the PoE Powered Device (PD). If the PoE
power being provided to the input fails, the battery seamlessly takes over continuing to provide PoE to the
device for up to 4 hours
Housed in steel IP66 rated enclosure
Installer friendly IP66 rated external cable glands offer plug and play solution
Powered remotely by PoE+ (PoE 802.3at)
Provides up to 14W to PD whilst charging the battery
Houses industry standard 12V 7Ah SLA battery
Deep Discharge protection
Fault Output
S
PECIFICATION
Input Specification
PoE+
Power Pin Assignment
Output Specification
PoE+
Power Pin Assignment
Standby Battery
Battery Type (not supplied)
Battery Charging Fuse protection
Mechanical
Dimensions
w x h x d (mm)
Battery Capacity
Weight (kg)
Enclosure Material
Environmental
Temperature
Technical Support Line +44 (0)23 9269 6638 (Option 3) POE-MINIPOD
Tel: +44 (0)23 9269 6638
Fax: +44 (0)23 9266 0483
B
ATTERY
PoE802.3at
4/5(+), 7/8(-)
PoE802.3at (16W max with battery charging)
4/5(+), 7/8(-)
12V 7Ah Valve Regulated Lead Acid
F1.25A
200 x 230 x 80
1 x NP7 (8Ah)
2.0
1.2mm steel grey powder coated
-10 to +40°C (operating) 75% RH non-condensing
PAK200793_01A Nov 2016
Web:
www.elmdene.co.uk
B
P
E S
ACKED UP
O
OURCE
© 2016 Elmdene International Ltd
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Elmdene POE-MINIPOD
- Page 1 POE-MINIPOD EATURES The Elmdene POE-MINIPOD is a unique PoE+ powered device that can charge a 12V 7Ah battery whilst continuing to provide a PoE compliant output (up to 14W) to the PoE Powered Device (PD). If the PoE power being provided to the input fails, the battery seamlessly takes over continuing to provide PoE to the device for up to 4 hours ...
- Page 2 NOTE: ensure correct polarity of battery connections: +ve use Red lead, -ve use Black lead. Observe RED LED is ON when PoE+ is present Observe PD indicates power is present Remove INPUT cable from POE-MINIPOD and observe PD continues to indicate power is present Reconnect INPUT cable Signalling Connect fault output to appropriate inputs of Control and Indicating Equipment (CIE) if required.
- Page 3 NSTRUCTIONS In the event of loss of PoE+ to the PoE-MINIPOD, the Fault signal contacts will open and the POE-MINIPOD will continue to deliver up to 14W PoE802.3at for up to 4 hours (dependant on charge state or capacity of battery) If the output of the POE-MINIPOD fails, the cause of the failure should be investigated e.g.
Need help?
Do you have a question about the POE-MINIPOD and is the answer not in the manual?
Questions and answers