DAD MOM Getting Started Manual page 11

Getting Started Guide MOM
The right-click menu has the following options.
Attach allows you to add more MOM's.
Remove will remove the selected MOM from the configuration.
Rename lets you rename the selected MOM for easier identification in the configuration.
Identify will make the selected MOM light up all green LED's for 10 sec. This makes it easier for you to
identify the MOM's if you have more than one on the same set-up.
LED Intensity lets you set the lighting level of the keys and LED's to either Low, Normal or High so it can
be adapted to the lighting conditions in the room where the MOM is used.
Default Preset will make the DADman software configure the functionality of the MOM based the
monitor profile. This is done on a "best effort" basis so it may not be perfect, but it can be a good starting
point. It is always possible to modify the configuration afterwards.
Assigning/re-assigning a key is done by simply right-clicking/CTRL-clicking on the key. This will bring up a
list of choices, including the monitor groups you have programme in the monitor profile. Pointing on a
monitor group will bring up choices from that monitor group. Select the functionality you want and then
proceed to the next key.
Finally, it is necessary to activate the layer(s) you want to use. Right-click/CTRL-click on a layer and select
Element Active to activate the layer.
Note. Element Active enables selection of the whole set of speakers on and off. Left
or Right enables that the selection is an on/off function for an individual speaker in the
set.
Doc no. MOM-8002-A-4
Figure 11, Assigning a functionality to a key
Rev. date 180220
Page 11 of 13