KLIM HTD Instruction Manual

Gauntlet glove

KLIM HTD Gauntlet Glove Instruction Guide

This guide is distributed to client of KAIWERKS, LLC to satisfy regulatory requirement by stating

the required information in the product's user manuals.

Subject: AHS (Active Heating System) module and variants

Alteration: This document has been modified for KLIM in their custom system in September

2019

How to use

Make sure your KLIM HTD Glove is fully charged. (24hrs is recommend for the 1

To turn on, press and hold the button for 3 seconds until the light indicator lights up Red

Short press to change between heating levels

HIGH Heat – indicated by the color RED

Please note that HIGH Heat is only available for 10 minutes at a time. After 10 minutes

your glove will automatically switch to MEDIUM Heat to preserve the temperature inside

the glove. HIGH Heat can be activated again by pressing the button until the indicator

light turns Red.

MEDIUM Heat – indicated by the color BLUE

LOW Heat – indicated by the color GREEN

To turn off, press and hold the button for 3 seconds until the light indicator disappears

Only charge the batteries that had experienced similar usage in pairs. Otherwise

assume 12hrs of charge time to balance the paired batteries

Remove the battery from the zipper pocket located on the inside of the glove

Let batteries warm up to ambient temperature before charging

Connect the charger to a wall socket and 2 green lights will come on. (Avoid using a

power strip with other appliances)

Check that the battery is dry and free of any condensation

Securely connect the charger terminals to the batteries

o Red light indicates the battery is charging

o Flashing green and red lights indicates 90% charge completed

o Green light indicates charging completed

**If the first red light change to green after connecting the second battery this

means the two pairs of batteries are out of balance and the charge will charge

the weaker battery first to ensure the pair is balanced

Always charge the batteries after use to prolong battery life

Always remove the batteries from the charger after charging is complete

Never charge the batteries below 0⁰C (32ºF) or above 40⁰C (104ºF)

charge)

Table of Contents

Do you have a question about the HTD and is the answer not in the manual?

Page 1 2019 How to use st Make sure your KLIM HTD Glove is fully charged. (24hrs is recommend for the 1 charge) To turn on, press and hold the button for 3 seconds until the light indicator lights up Red Short press to change between heating levels HIGH Heat –...
Page 2 · Never charge batteries unattended · Only use supplied charger for charging. Using other charging devices and batteries will void your warranty and may cause damage · It is always recommended to charge the battery in an isolated area, away from other flammable materials.
Page 3 Legal Disclaimer · Except to the extent prohibited by local law, in no event will KLIM or its subsidiaries, affiliates or suppliers be liable for direct, special, incidental, consequential, or other damages (including loss of profit, cost of procurement of substitute products), arising out of the use, inability to use, or the result of use of the product, whether based on warranty, contract, tort or other legal theory, and whether or not advised of the possibility of such damage.
Page 4 (“Warranty Period”). If a defect arises and a valid claim is received within the Warranty Period, then as your sole remedy (and KLIM sole liability), KLIM will at its option either 1) repair the defect at no charge, using new or refurbished replacement parts, or 2) replace the Product with a new product that is functionally equivalent to the original, in each case within 60 days following receipt of the returned Product.