IBEST CRN Series Quick Start Manual

CRN SERIES
Dear clients, thanks for choosing IBEST CRN Series (48×96mm) Counter! Before installing and operating the products, please read this
instruction manual carefully. For any questions, please contact our sales people immediately.
! SAFETY CAUTIONS:
● Make sure the power is at "OFF" status before connecting the wires to avoid electric shock and strictly follow the connection diagram
given out by the factory.
● Make sure the power OFF when cleaning the product.
● Working beyond the stated power supply (90-250V AC) is prohibited so as to avoid damage to the product or cause fire.
● Make sure the OUTPUT RELAY is used at the rated load and electrical life, if the contact of the output reply works against the electrical
life, it may melt or burned or even cause fire.
● Install power switches and circuit breaker for power safety.
! STOCK AND MAINTAINENCE NOTICE:
● Try to avoid interfere headstream, input signals cable should not be too long, better to use twisted-pair shielded cable, shielded layer
connected with singals low end.
● Prevent from violent vibration, shock and incursion of heavy dust.
● Stock long terms at 0~50
● When instrument power supply has noises, paticularly when inductive voltage caused by relay or contact devices switch ONand OFF
result in serious interference, must configure filter or rheostat or noises absorber.
1.FEATURES
● Preset counter meter (length meter), soft buttons operation, easily operate
● 4 or 6 or 8 LED display
● Counting mode: counting Up or counting down
● CP1, CP2 input, reset signal input; input mode: voltage(PNP),non-voltage input (NPN)
● Relay and tansistor output; optional control output: N, F, C, R
● Counter speed: 30/300/1000/3000 HZ,selectable by software
● Modulus can be set up to 0.000 ~ 99.99 (4 digit), 0.00000 ~ 99.9999 (6 digit), 0.000000-99.999999 (8 digit)
● Power fail holding function, up to 10 years.
● Reset modes: manual reset, auto reset, external reset
● Dimensions: 48X96mm
● Application: can be used with photoelectric sensor, proximity switch, and rotary encoder in the fields of machinery, light industrial, packing and packaging,food
and beverage, for measure length, counter etc.
2.ORDERING CODE
Preset counter (length meter)
(soft buttons)
Relay & transistor
4 digit display
6 digit display
8 digit display
3.PANEL INSTRUCTIONS
a. 48×96mm panel instructions
Output indicate lamp
Manual reset key
P
1
Preset Digital Counter
PREREAD INSTRUCTIONS
, under 35~856RH environment.
R
C R N
Display counting value / set value
OUT
RST RST RST
Operation mode key, press 3s to enter
www.ibestchina.com
IBEST ELECTRICAL CO.,LTD
4 C
1 4
C
L
4
7
4
8
6
1
8
2
SET2
SET1
MODE RST RST
RST RST RST RST
into operation mode menu
Electrical & Automation
Counter
Length meter
48W×48H dimension
72W×72H dimension
96W×48H dimension
1 preset
2 preset
Displaying value
indicate lamp
Value increase key or
parameters convert key
Digit shift key