Before attempting to connect, operate or adjust this product, please save and read the User's Manual completely. The style of the product shown in this User's Manual may be different from the actual unit due to various models. Safety Instructions Always read the safety instructions carefully: ◆...
Regulatory Compliance FCC Conditions This equipment has been tested and found to comply with Part 15 Class B of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received and include interference that may cause undesired operation.
Introduction The Diamond Thunderbolt 3 Titan Ridge Mini Dock is DPD ( Dual Powered Device ), designed for bus-powered or self- powered dual-mode usage with extra connectivity demands and supports one DP 1.4 and one HDMI 2.0 output with HDR. With the Docking station, you can extend the...
Package Contents ◆ Diamond TB3MDS Thunderbolt 3 Mini Dock System Requirements ◆ Supported Operating System – ® Windows – Mac OS ® ( macOS 10.15.3 above)
Product Overview Front Item Description 1. DisplayPort 1.4 Connect to the DP monitor 2. HDMI 2.0 port Connect to the HDMI monitor RJ45 port Connect to an Ethernet...
Page 9
Rear Item Description 4. Combo audio jack Headset 5. USB-A 3.1 Gen 2 x2* Connect to USB devices *When self-powered mode, it can support USB 3.1 Gen 2 x 2, when bus-powered mode, it can support USB 3.1 Gen 2 x 1 and USB 2.0 x 1, 1st come 1st serve.
Page 10
Side Item Description Connect to the USB-C power adapter 6. USB-C PD power in (USB-C Power adapter should be 60W or higher.)
Connection To connect the USB peripherals, Ethernet, speaker, and microphone, follow the illustrations below to connect the corresponding connectors.
Page 12
NOTE: The following strings and screenshots may vary slightly from each operating system Windows® 10 Select Always Connect to approve the device connecting, then click OK.
Page 13
To make sure the devices have been connected. Click on the desktop on the corner of the screen to open Thunderbolt Software. In the window that appears the device has been connected.
Audio configuration By default, when the docking station is connected to a computer, the audio configuration may be changed to USB (Multimedia) Audio Device automatically (this setting depends on models). If it does not work, follow the steps below to setup. 1.
Page 15
Specification Upstream USB-C Thunderbolt 3 x1 User Interface DP1.4 connector x1 Downstream HDMI 2.0 connector x1 USB-C x1 (Power in only) USB-A 3.1 Gen 2 x2* RJ45 connector x1 Combo Audio Jack x1 Single 8K@30Hz or Dual Resolution Video 4k@60Hz Type 10/100/1000 BASE-T Ethernet...