Summary of Contents for Optimum ESI-100 IP-PBX
- Page 1 ESI - 100 IP-PBX SIP Trunking using the Optimum Business Sip Trunk Adaptor and the ESI-100 IP-PBX...
-
Page 2: Table Of Contents
ESI - 100 IP-PBX Table of Contents 1. Overview 2. Prerequisites 3. ESI-100 Configuration 3.1 Network Settings 3.2 SIP Programming 3.3 Extensions/DID 3.4 Backup/Restore... -
Page 3: Overview
2 Prerequisites Please follow the instructions in the Optimum Business SIP Trunk Set-up Guide. The set-up guide was left by the Optimum Business technician at installation. If you do not have the set-up guide, go to optimumbusiness.com/sip to download a copy. -
Page 4: Network Settings
Navigate to Program>F8 IP Programming>F82 Local Programming>F824 NSP IP Programming and enter the address of the management port under NSP Private IP Address and the address of the Optimum Business Sip Trunk Adaptor under NSP Gateway IP Address. Next navigate to Program>F8 IP Programming>F84 SIP Card Configuration Programming. -
Page 5: Sip Programming
The Pilot DID, credentials, and SIP information should be entered in the fields that follow. The address of the Optimum Business Sip Trunk Adaptor should be entered under ITSP URI and Outbound Proxy. The RTP port range was “10000-11000” and... - Page 6 ESI - 100 IP-PBX Now navigate to Program>F2 CO Lines>F21 CO Lines>F214 SIP Line Programming>F2141 SIP Trunk Programming. The ITSP Name which in this case was “ESI” should be included for SIP Trunks 24-31 as shown. ID 1 under Ring 1 (Day) represents the Auto Attendant.
-
Page 7: Extensions/Did
ESI - 100 IP-PBX For Static mode exclude the credential section under F2142 SIP Account Programming and confirm the device’s SIP port address remains specified under F84 SIP Card Configuration Programming. The vendor option can be one that excludes the registration fields. VOXITAS -FS in this example was chosen. 3.3 Extensions/DID To configure extensions and DIDs navigate to Program>F2 CO Lines>F22 CO Access Deny Tables>F224 DID &... - Page 8 ESI - 100 IP-PBX To control the behavior of particular outbound numbers navigate to Program>F2 CO Lines>F22 CO Access Deny Tables>F222 Toll Restrictions and here numbers can be allowed or denied. Note: The Cablevision network supports Inband DTMF only. ESI uses Inband DTMFby default and this is not an configurable option.
-
Page 9: Backup/Restore
ESI - 100 IP-PBX 3.4 Backup/Restore To backup the device file simply right click the site and navigate to Backup followed by System Programming. Once a backup has been performed, a backup folder will appear under Program. Right click this folder to restore.
Need help?
Do you have a question about the ESI-100 IP-PBX and is the answer not in the manual?
Questions and answers