Table of Contents
Related Manuals for Intenda BOX TUNNEL
Summary of Contents for Intenda BOX TUNNEL
- Page 1 INSTALLATION, USE AND MAINTENANCE BOX TUNNEL BOX TUNNEL STADIO BOX INTENDA S.r.l. Via V. Pareto, 3 37045 S. Pietro di Legnago (VR) Tel +39 0442 601031 – 600270 Fax +39 0442 25164 http://www.intenda.it - e-mail: info@intenda.it...
-
Page 2: Table Of Contents
TABLE OF CONTENTS 1. GENERAL INFORMATION…………………………………………………………………..3 1.1 Introduction………………………………………………………………………………..3 1.2 General precautions regarding the use of the product…………………………………….4 1.3 Structure of the manual……………………………………………………………………….4 1.4 Product identification…………………………………………………………………………..5 1.5 Warranty………………………………………………………………………………………..5 2. BOX DESCRIPTION AND TECHNICAL SHEET…………………………………………..6 2.1 General description………………………………………………………………………….…6 2.2 Components…………………………………………………………………………………….7 2.3 Fabric’s characteristics……………………………………………………………………….10 3. -
Page 3: General Information
In the event of damage that makes the copy of the manual in its possession unusable, the user can request a copy from Intenda S.r.l., specifying the type of structure, the serial number or order shown on the nameplate of the structure itself. -
Page 4: General Precautions Regarding The Use Of The Product
1.2. General precautions regarding the use of the product These indications are part of the normal behavior that workers must have towards the product and therefore in the design and construction of the product, the manufacturer considered them known to the tenant. -
Page 5: Product Identification
The physical identification record is the silk-screened and stamped plate which contains the details to be cited, in case of need, to the company Intenda S.r.l . This plate is the only one recognized by the manufacturer as a means of product identification. For no reason the data shown on the product can be altered. -
Page 6: Box Description And Technical Sheet
In the box building process INTENDA S.r.l. uses materials and mechanisms of suitable type, state and quality, at its own discretion; even after the receipt of the order, INTENDA S.r.l. can make substantial changes or appropriate improvements at its own discretion. -
Page 7: Components
B (cm): da 150 a 300 D (cm): da 180 a 240 NB. Starting from the length (A) of cm 700 (only for mobile version): eyelets placed on the lateral profile for ground-fixation through straps and stakes/ballasts (not supplied by Intenda) 2.2. Components... - Page 8 PVC SLIDING CURTAIN PVC WALL WITH WINDOW IN MICRO-PERFORATED MATERIAL ALUMINIUM CROSSBEAM GROUND-FIXING BRACKETS* (base v.), NYLON WHEELS (mobile v.) *Only for Box Tunnel and Box Tunnel Eco *Only for Box Tunnel...
-
Page 10: Fabric's Characteristics
2.3. Fabric’s characteristics POLY LG 550/LAC 2L FLAME-RETARDANT BOX TUNNEL – STADIO BOX Yarn Warp: 100% PES 1100 Dtex Weft: 100% PES 1100 Dtex Fabric’s weight 550 gr/m Characteristics ABUV Finishing gloss lacquered Breaking strength Warp: ca 250 DaN/5 cm... - Page 11 STARPOL 650 LAC BOX TUNNEL ECO Yarn Warp:100% PES/1100 Dtex Weft:100% PES/1100 Dtex Fabric’s weight Ca 650 gr/m Finishing PVC coated 2 sides Breaking strength Warp: ca. 250 DaN/5 cm (DIN 53354) Weft: ca. 230 DaN/5 cm Tear strength Warp: ca. 25 DaN (DIN 53363) Weft: ca.
-
Page 12: Installation
3. INSTALLATION ATTENTION: Intenda S.r.l. recommends a preventive investigation by a competent technician, for a detailed analysis of the urban planning regulations in force in the installation area of the box. The manufacturer assumes no responsibility for installations in areas (floors) not suitable for supporting the static and dynamic loads of the structure or in areas where the stresses deriving from atmospheric phenomena can cause permanent damage to the structure. -
Page 13: Box Installation
Allen key (photo 3). ATTENTION: if the screws in the crosses top are released, it can cause serious damages to the structure and to the cloth of the box. Intenda S.r.l. is not responsible for this kind of damages. - Page 14 Subsequently, the box must be opened by pushing the crosses from the bottom to the top (photo 4/a and 4/b). The top cover must be stretched: • BASE VERSION: using the stretching device (not included) and tightening the screws of the lower part of the crosses (photo 5/a, 5/b and 5/c) •...
- Page 15 Finally, the box can be fixed to the basement through appropriate anchorage systems. ATTENTION: other installation ways which are not contained in this manual are not allowed, if not previously authorized by INTENDA S.r.l. ATTENTION: the box must be fixed to the ground and/or to a wall. The installer must verify the ground type and conditions and choose the appropriate anchoring system, also considering the typical meteorological conditions of that particular place (strong wind,).
-
Page 16: General Safety Principles
4. GENERAL SAFETY PRINCIPLES It is recommended to follow the safety requirements indicated on the structure and into the installation manual. Do not remove or modify the safety devices. The utilization of the product should be in accordance with the producer indications. The safety indications does not refers only to new products, but also to already used products. -
Page 17: Box Usage
5. BOX USAGE Before using the box, it is necessary to check that the installation has been done properly. ATTENTION: check that the structure is not damaged or deformed, and that no one of the component is broken. 5.1 Mobile version •... - Page 18 It is not possible to use the box in conditions of strong wind and/or snow. In order to use the product during these adverse conditions, a written declarations by Intenda is needed. Every modification of the product which changes the functionalities of the box and subsequently modify the risks, have not been authorized by the constructor.
-
Page 19: Checks And Maintenance
6. CHECKS AND MAINTENANCE It is necessary to periodically check the general state of the structure, of the connections between the various components, of the and the PVC awnings. The PVC awning can be washed with mild soap and then rinsed with water only. After the cleaning, the PVC shall be well dried before fold, in order to avoid the creation of moulds, The checks and maintenance frequency indicated below is to be considered as the minimun interval to grant efficiency, security and durability of the product of the product in normal use situations. -
Page 20: Disassembly
Respect also the manufacturer’s provisions. We evaluate a product life duration of 10 years. After this period of time, it is necessary to have a check from an Intenda S.r.l. technician, who will analyze the remaining life period.