NESLING Coolfit Instructions page 2

1
2
3
4
5
1. Mark The Holes
Determine how far apart your holes should be.
Install Brackets
Install the Clutch an Idle End Brackets.
The Clutch Unit Bracket will be on the right side and the Idle End Unit Bracket
should be on the left for standard installation. Do not tighten screws completely yet.
2. Install the Shade
First, insert the Clutch Plug into the Clutch Unit.
Then insert the Idle End Plug into the Idle End Unit, and snap the Idle End Plug
securely into place.
shade.
IMPORTANT:
Now go back an tighten the Bracket screws completely.
3. Install Tension Device
The Tension Device reduces potential hazards associated with having a loose chain
hanging from the shade.
First hold the Tension Device so the warning tag hangs beneath it.
tension Device and chain do not interfere with raising and lowering for any slack.
Do not twist, cross or slant the chain.
Holding the Tension Device upright, secure with screw. Use a screwdriver to lift the
front lip and slide chain thru.
4. Install Tie Downs (IF DESIRED)
moderate wind conditions.
NOTE:
If you choose to use the Tie Downs, you will need to install something to anchor
them to. Many customers have used: u- shaped hooks, s-shaped hooks or screws.
5. Adjusting Chain Tension
You can adjust chain tension if needed.
four (4) screws: turn counter clockwise. If chain tension is too loose (chain pulls too
In severe wind or prolonged exposure to wind,
First, remove the End Caps from either end of the Bottom Rail. Then,
slide the Tie Downs into the channel/groove. Reinstall the End Cap.
© 2018 Copyright Nesling B.V.
T H E P E R F E C T S H A D O W
www.nesling.com