Honda LPC Series Manual

Crimping tool
This manual describes how to properly handle the crimping tool
manufactured by HONDA TSUSHIN KOGYO CO., LTD.
1. Characteristics
1. Compact light-weight crimping tool.
2. The crimping tool is easy to use because the gap
between the fully opened handles is small for
operator comfort.
3. Eccentric force movement from the handle to the
anvil enables anyone to easily crimp wires and
terminals.
4. Additional force is not required when the ratchet is
released.
5. The attached cable stopper ensures proper
crimping.
6. The adjustable crimp height ensures appropriate
crimping. (*1)
*1. The crimp height has been adjusted at the
factory. However, it may change due to long-term
use. When changed, correct the crimp height by
using the pushing bar and adjusting nut.
(The longer pushing bar increases the crimp
height, and the shorter pushing bar decreases it.)
2. Notes on Use
1. Verify that the crimping tool matches the size of the terminal or wire to be crimped before using the tool. (All the
tools have similar appearances. However, a tool can only be used for the applicable terminals.)
2. Check the validity of the crimp height after the wire is crimped.
3. Do not remove the screws from thee tool and do not disassemble the tool. Otherwise, a failure may occur.
(Repair of the tool with any parts manufactured by another company may also cause a failure.)
4. Do not abuse the tool.
5. If you want to use a special wire, please contact a sales person or the Engineering Department.
Through
SMT Press-in IDC
hole
Wire
Soldering Crimping Others
wrapping
Tools
Crimping
About 42
About 105