Lakes Coastline hinge bypass is fully reversible so can be fitted to LH or RH products.
Installation may be carried out at same time as parent unit, OR at a later date.
A
If already fitted, carefully cut silicone & remove the corner trim from bottom glass corner.
Thoroughly clean & dry edge of glass, top to bottom. At this stage it is recommended to
check that the bypass panel will fit to the glass edge - in particular check that bottom
hinge & gasket fit beneath glass corner ** right upto the base trim
B
Glass corner gasket
1.
check that the glass corner gaskets are fitted to both hinges, then
2.
With panel carefully supported, apply a continuous bead of clear silicone sealant along
entire length of glass groove (& into hinge recesses).
**