Temboo KOSMOS Starter Kit Setup Manual

Hide thumbs

Table Of Contents

KOSMOS

Starter Kit Setup Guide

What will this guide teach me?

15 minutes

This guide contains step-by-step instructions on how to set

up your Kosmos Industrial IoT Starter Kit.

Once you've ﬁnished these steps, you'll be ready to start

gaining valuable insights from your sensor data using

Kosmos' dashboards, alerts, and more.

For questions about setting up your Kosmos IoT System,

please email

support@temboo.com

and we'll get back to

you as soon as possible.

Table of Contents

Need help?

Do you have a question about the KOSMOS Starter Kit and is the answer not in the manual?

Questions and answers

Summary of Contents for Temboo KOSMOS Starter Kit

Page 1 Once you've ﬁnished these steps, you'll be ready to start gaining valuable insights from your sensor data using Kosmos' dashboards, alerts, and more. For questions about setting up your Kosmos IoT System, please email support@temboo.com and we'll get back to you as soon as possible.
Page 2 NCD Wireless (Raspberry Pi Model 3 B+) Wireless Sensor Modem Raspberry Pi 5V 2.5A Ethernet Cable NCD 12V 3A Power Adapter Power Adapter Micro SD Card USB Micro SD USB Flash Drive (8+GB, US 3) Card Reader Questions? support@temboo.com Page 2...
Page 3 Connect NCD Modem Connect the NCD modem to your gateway via the USB cable provided. Insert USB Drive Insert the USB thumb drive into any available USB port on your Kosmos gateway. Questions? support@temboo.com Page 3...
Page 4 PS (power select) jumper parallel to the marking line on the board. The power select (PS) jumper on your NCD sensor. Slide the plastic jumper up and place it back down on the outer two pins, parellel to the white marking line. Questions? support@temboo.com Page 4...
Page 5 Note: You can press the reset button on your NCD sensor to force another sensor reading to appear in the graph. Make sure to refresh the graph in your dashboard after pressing reset. Questions? support@temboo.com Page 5...
Page 6 ﬁle. Eject the USB drive from your computer and insert it back into your Kosmos gateway. Remove the gateway’s power supply and reconnect it. Your Kosmos gateway will power back up and connect via WiFi. Questions? support@temboo.com Page 6...
Page 7 If you still don’t see data, double- check that the power supply for your sensors (adapter or batteries) is working correctly. Press the reset button on the sensor and refresh the browser in which you are viewing the sensor graph. Questions? support@temboo.com...