Advertisement
®
ZeroWater
Filter Bottle
Use and Care Instructions
Please read before fi rst use.
INSTRUCTIONS BEFORE INSTALLING CARTRIDGE
AND FIRST USE
1. Clean all plastic components and fi lter cartridges by washing and rinsing
thoroughly with warm water only. Rinse the Filter Bottle thoroughly when washing
with soap.
2. Note: the Filter Bottle components, fi lter cartridges and TDS meter are not
dishwasher safe.
3. Discard all plastic bags. This may be a suff ocation hazard to young children.
ASSEMBLY
1. Take the lower chamber and place the lower chamber divider
rim fi rmly on the top. The rippled part of the white rim should
be overlapping the lower chamber. If assembled upside
down, there will be leakage. Be sure it fi ts tightly on the
lower chamber (see ZeroWater
on page 4).
2. Screw fl oat valve tightly into hole on bottom of lower
A
chamber (inset A). Do not prop the Filter Bottle on the fl oat
valve once assembled, as it is fragile and will break.
3. Place the lower chamber on top of your cooler with the
fl oat valve fi tting inside the cooler's reservoir (see Using
Your ZeroWater
on page 6).
4. Install fi lter cartridges now, using steps 1 and 2 from
instructions on next page.
5. Place the upper chamber on top of the lower chamber. Be
sure that the lower chamber divider ring is tightly affi xed
around the lower chamber (see ZeroWater
components on page 4).
®
Filter Bottle components
®
Filter Bottle with a Standard Water Cooler
®
USE AND CARE
5
Filter Bottle
Advertisement
