Table Of Contents - Sam -III Construction Manual

Section
I. Description
II. General Building Tips
III. Separate the Controller PCB and Keyboard PCB
IV. Install Keyboard Components
V. Install the Power Supply Components
VI. Test the Power Supply
VII. Install the Logic Circuits
VIII. Install the Display Components
IX. Install the Ribbon Cables
X. Wire the EIA-232 Serial Port Cable
XI. Testing and Adjusting
XII. Load the Microprocessor Operating System Firmware
XIII. SAM Display and Keyboard Reference Information
XIV. Install the Controller, Keyboard and LCD in the Enclosure
XV. Magnetometer Sensor Hookup
XVI. Magnetometer Sensor Installation
XVII. Temperature Sensor
XVIII. Circuit Description
Appendix Using SysInternals PortMon
Document History
File: SAM-III Magnetometer Construction.doc, Page 0
SAM-III Construction Manual

Table of Contents

Page
1
3
4
5
7
11
13
17
18
20
23
36
44
47
53
63
69
71
77
80