Table of Contents
Advertisement
When cannot be repaired in the IC exchange, and in the case of performing the "Main P.C.B." exchange, carry out any of following.
1. When it can turn on power, and the adjustment software can communicate with the camera body:
Before replacing, proceed the Flash-ROM (IC2003) data backup from the unit.
After replacing, overwrite the Flash-ROM (IC2003) data with backup data from the unit.
After that, proceed the main body adjustment. (Almost adjustment/inspection items can be omitted.)
Refer to the adjustment instruction in the adjustment software for details.
2. When it cannot turn on power, or the adjustment software cannot communicate with the camera body:
Almost readjustment fully are necessary.
The details are refer to adjustment manual in adjustment software.
*5 NOTE: (When White Balance (WBL/WBM) adjustment)
After change to WB adjustment mode for service with software, the adjustment is executed.
After adjusting the AWB adjustment, to cancel the WB adjustment mode for service.
The details are refer to adjustment manual in adjustment software.
*6 NOTE: (About the G sensor adjustment)
Offset adjustment for built in electronic level.
The details are refer to adjustment manual in adjustment software.
*7 NOTE: (About Gyro sensitive/DC offset adjustment)
Gyro adjustment for BIS. Put to a normal state and execute automatic adjustment.
The details are refer to adjustment manual in adjustment software.
About the 3D interchangeable lens (H-FT012) correspondence
This unit has no special structure (circuit or part) for the 3D interchangeable lens correspondence, only by software is processed the 3D
interchangeable lens correspondence.
Therefore, if taken with other lenses as usual, the 3D interchangeable lens is no problem for operation.
file:///C|/U...LLSVC_DSC1703003CE/viewing/SGML_VIEW_DATA/ALL/DC-GH5P/SVC/DSC1703003CE/doc/DSC1703003CE_10.xml[11/12/2018 4:48:55 PM]
Advertisement
Table of Contents
