Tools Required; Product Disassembly Process - HP ProCurve 530 WW Product End-Of-Life Disassembly Instructions

2.0 Tools Required

List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Torx Driver with center cavity (tamper-resistant)
8 mm wrench or adjustable wrench.
Flat blade screw driver
Wire cutter

3.0 Product Disassembly Process

3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove chassis mounting screws on bottom, typ 6 screws.
2. Separate bottom plate, PCA, and top plastic cover.
3. Unplug antenna cables from PCA, then unscrew antenna connectors from plastic cover.
4.
5. For power adapter:
6.
7. Split plastic case using small flat screw driver.
8. Cut wires using wire cutter and remove PCA.
9.
10.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items
contained in the product that require selective treatment (with descriptions and arrows identifying locations).
EL-MF877-00
Template Revision A
Tool Size (if
applicable)
# 10
8 mm
# 1
Medium
Page 2