Tanova Simplex Plus Installation Instructions

SIMPLEX PLUS KITCHEN WASTE AND LAUNDRY SYSTEM
INSTALLATION INSTRUCTIONS
FOR RUNNER POSITIONING WITH WASTE BUCKETS
1. RUNNER POSITIONING TEMPLATES are on either short end of the assembly template
provided.
• Hold template against the underside of the cabinet top rail and right hand
cabinet side flush with the front and mark runner fixing positions as shown on
template.
• Repeat on left hand side
2. Turn bin mechanism upside down on a bench. Remove runners by removing retaining
screw and washer at the front of the runner.
3. Fix runners to cabinet using 3 screws per tab minimum.
4. Extend runners out the front of cabinet. Slide bin frame onto runners and engage tabs
at rear. Refit retaining screws and washers through runners into frame assembly.
5. DRAWER FRONT TEMPLATE is on the long edge of the template provided.
On the back of the drawer front, mark the centre line of the drawer front.
•
Measure down from the top of the drawer front the desired amount of cabinet
overlay.
Align the template centre marks with the drawer front centre line.
•
Move template upwards until flush with previously marked position. Mark fixing
•
points.
6. Fix drawer front to bin frame and adjust using 6 way adjustment points.
7. Ensure all adjustment screws are firmly tightened.
Last updated:14 March 2018
For further assistance in New Zealand
www.tanova.co.nz 0800 852 258
For further assistance in Australia
www.tanova.com.au 1300 123 700