Abbyson P3 User Manual

Abbyson P3 User Manual

Universal rechargeable battery pack

Advertisement

Quick Links

ABBYSO
Thank you for your
To protect you from electric hazards, please read the user manual
Proper use of the product will help extend the lifecycle as well.
1.
Please use the original charger to charge for the battery pack. Non-authorized
chargers may damage the product.
2.
The specification for the charger is DC 29V 0.8A-2A. Please ensure to use the correct
voltage charger.
3.
Avoid putting the battery pack close to heat sources. Avoid using it when the room
temperature is over 100 degrees F.
4.
Avoid immersing it in any liquids.
5.
Avoid dropping, crushing, throwing, striking and shaking the product.
6.
Never inserting anything into the unit.
7.
Avoid having the product repaired by unauthorized personnel. Please contact your
place of purchase if it is not working properly.
8.
Never operate the unit if it has a damaged cord, power or plug.
9.
Never operate the unit if its over-heated or deformed.
10. This product is made for Indoor use only, and please avoid exposure to direct sunlight.
For assistance with assembly or customer service, please contact the Abbyson Customer Experience Team
very carefully before operating.

SAFETY WARNINGS

Toll Free at 1-888-406-0838
www.abbyson.com
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Abbyson P3

  • Page 1 Never operate the unit if its over-heated or deformed. 10. This product is made for Indoor use only, and please avoid exposure to direct sunlight. For assistance with assembly or customer service, please contact the Abbyson Customer Experience Team Toll Free at 1-888-406-0838...
  • Page 2 Press to check the Power Status P3 Capacity: 2,200 mAh P3 (1 battery) Life Cycle Count 1 motor (power feet): Approx. 350 cycles 2 motor (power feet and headrest): Approx. 250 cycles 3 motor (power feet, headrest and lumbar): Approx. 125 cycles Charging voltage: 29.4VDC / 56.98 Wh...
  • Page 3 • Remove the power supply for the recliner. • Follow the wiring drawing to connect the battery pack to your recliner. • for 2 seconds to check the power state of the charge. Press 1 Light: State of Charge at 25% 2 Lights: State of Charge at 50% 3 Lights: State of Charge at 75% 4 Lights: State of Charge at 100%...
  • Page 4 ATTENTION • When the State of Charge is less than 10%, the battery pack will stop automatically. Please recharge the battery pack to reset it. • Never disconnect the battery pack when it is discharging. • The overload protection for the battery pack is 10A. The battery pack will stop discharging when the load reaches 10A and could not discharge unless you charge the battery pack to reset it.

Table of Contents