Masco LaGard LG BASIC Instructions

Suggested Keypads
3000 Round Entry

FEATURES

MANAGER CODE
(Factory set to 1-2-3-4-5-6)
Add/Remove User
Enable/Disable User
USER CODE
Open Lock
Change Code

WRONG TRY PENALTY

Four (4) consecutive invalid codes initiates five
minute delay period.

LOW BATTERY WARNING

Repeated audio and visual signal (LED flashing and
repeated beeping) during opening indicates battery low.

AUDIO AND VISUAL SIGNAL

Double signal (LED flashes and unit beeps) indicates
entry is valid or accepted.
Triple signal indicates invalid or not accepted.
© copyright 2003 12-219V1
MANAGER PROGRAMMING
3710 Angular Input 3900 LGACCESS
3765-2 Dual-Handed Swingbolt Lock Instructions

OPENING THE LOCK

Enter valid six (6) digit code.
The lock will indicate a valid code entry with a double signal.
Within four (4) seconds, turn handle to the open position.
Pull door open.
Invalid Code Entry - Lock will signal three (3) times.
Security Considerations - On safes using more than one
lock the swingbolt lock must lock first.

CHANGING YOUR CODE

ALWAYS PERFORM THIS OPERATION WITH
THE DOOR OPEN
Enter "zero" six times.
Enter your existing six (6) digit code one time.
Enter your NEW six (6) digit code two times.
If a mistake is made wait thirty (30) seconds and repeat
steps
Test lock operation several times before closing the door.
Handle
Valid Code Entry - Double signal after valid six (6) digit
code is entered.
Invalid Code Entry - Triple signal and old code is still valid.

ADD USER

ALWAYS PERFORM THIS OPERATION WITH
THE DOOR OPEN
Enter Manager code and HOLD DOWN LAST DIGIT of
CODE until the lock signals with two sets of double beeps.
PRESS 1. Lock signals twice.
Enter user code twice. The lock signals twice after each
valid entry.
If a mistake is made wait thirty (30) seconds and repeat
steps
Valid Code Entry - Double signal after valid six (6) digit
code is entered.
Invalid Code Entry - Triple signal and old code is still valid.

DISABLE USER

ALWAYS PERFORM THIS OPERATION WITH
THE DOOR OPEN
Enter Manager code and HOLD DOWN LAST DIGIT of
CODE until the lock signals with two sets of double beeps.
PRESS 2. Lock signals once.
User is temporarily disabled.
If a mistake is made wait thirty (30) seconds and repeat
steps
Valid Code Entry - Double signal after valid six (6) digit
code is entered.
Invalid Code Entry - Triple signal and old code is still valid.
- .
- .
- .
LA GARD INC - A MASCO COMPANY