CLS-1 detector
operating instructions
Function introduction
1、Both sides indicator light display
Heads and tails are high brightness signal light is used to indicate the laser line position
2、Free automatic shutdown
When the detector receives no laser line, and lasted 7 minutes did not press any key will
automatically shutdown in power saving
3、Low voltage alarm
When battery voltage is low, the power indicator light will flash to notify the user to replace new
batteries as soon as possible
Matters needing attention
1、
Please try to avoid in damp and dust under the environment of use for a long time
2、
Please feel free to keep receiving window cleaner, and careful not to yank
3、The detector shall not without authorization, remove or modified without permission
4、
Please don't put the detector in high temperature environment, the detector storage temperature was
minus 20 ~ 60 ℃
5、
Please avoid let detector by dramatic impact or vibration
6、
Please don't you push hard on the button
7、
Please use dry clean soft cloth to clean water and dust on the surface of the detector, cannot use
cleaner or gasoline scrub
8、
The detector is not used for a long time should remove the battery
9、Please don't in strong electromagnetic field or high light environment using this detector
10、This detector is also of strong fluorescent lamp, the sunlight, flashing light and alternating induction
radio signals, and the source of these signals will affect the actual measurement of this detector,
produce certain error
Caption