Table of Contents
Advertisement
SonarMite DFX v1.20 (c) Lymtech 2016
APPENDIX
SonarMite Settings
The SonarMite when connected via Bluetooth to a serial communications program such as
Hyperterminal has a basic set of simple dual character commands used to set the basic
parameters of the instrument.
Flash Memory
The instrument contains an area of configuration data held within its semi-permanent FLASH
memory area. On running the instrument this data is copied into the current working RAM area
of the processor. Pressing any of the configuration command characters will only change the
current active states enabling the user to sample output unil the „Save‟ command is used to store
the current settings and make them the new defaults when the system is rebooted.
DFX version Commands
☺
(^H)elp
Pressing ^H (Contol H) will display the following help information as an aid memoir to the
available commands...
^Help,Format,Version,Id,Save,[Reset,Load,U/Dsos]
Commands shown in parenthesis [ ] are only available in the SYS> format.
Memory Operations
☺
(^R)eset
Pressing ^R (Contol R) will reset the SonarMite to its default values, these values are saved in
Flash memory and set in current working RAM memory
(only available in the SYS> output
mode).
Page 17 of 26
Advertisement
Table of Contents
