Troubles And Errors - ABB HART HHT 275 Manual

3 TZID-C
1 Ident no.
Display the TZID-C/TZID-C200 serial number.
2 Hardware rev
Display the TZID-C/TZID-C200 hardware revision
3 Software rev
Display the TZID-C/TZID-C200 software revision.
4 Valve ID no
Display the TZID-C/TZID-C200 manufacturing number.
5 Sensor type
Display the sensor type.
6 PV Snsr s/n
Display the sensor number.
7 Actuator
Display the actuator type (linear or rotary actuator)
10

Troubles and Errors

If the communicator cannot set up the communication with the positioner, the message
"No device found" is displayed. Check the connection (cables) to the device, and
acknowledge the message with
"Online" option from the displayed menu.
If the communicator displays the message "Device busy" while attempting to transmit a
changed parameter value to the TZID-C/TZID-C200, this indicates that another connec-
tion (e.g. via the configuration program on the PC) to the connected device is currently
active. Press
14
F4
(Retry) to restart transmission.
F1
Troubles and Errors
(OK). Restart communication setup by selecting the
Troubles and Errors
42/18-75 EN